













Swivel Caster Wheels 600lbs,2 Inch Casters Set of 4, Heavy Duty Casters with Brake,Premium Dual Locking Castors with Plate for Cart, Furniture, Workbench, Trolley(16pcs Screws Included)
-
Kdad
> 3 dayGreat heavy duty casters. I have a 5’x5’ heavy work bench that these support and I have moved a lot of lumber and they have held up great. The locks are very solid and you only have to lock two of them to stop the bench from rolling.
-
DLG
> 3 dayI first looked due to the orange color... They looked great and were heavy duty. I used them for caster wheels on a dolly I built for my Harley Electra Glide. So Im putting 250+ lb per wheel... If you look close, I removed the brakes off this side (kept them on the other side). It does not affect the wheel at all. I would buy them again in a heartbeat. Thanks!
-
Rusted Nut Garage
> 3 dayI will make the assumption that 1300 pounds means all four will handle that much weight. I bought this because I need a stand for a 425 pound oven. This should be more than up to the task. If not then I will be removing some stars and adding some more comments. A nice surprise was the small bag of 16 nuts and bolts for mounting. Just make sure you have a 14 mm wrench available since these are metric. If you require lock washers then 5/16 work just fine. They have a very nice brake lock for each wheel.
-
Matthew Barricelli
> 3 dayPlate is advertised as 68mm x 95mm, arrived and each measured at 62mm x 93mm. Not a big problem if you are building something from scratch but trying to use these as a replacement for broken/old wheels without modifying the cart may be frustrating. Also, whatever bearing they used for the plate feels crunchy. wheels are fairly smooth but do have play due to an undersized bolt and bushing that goes through the bearings. The force to apply the wheel brake is also quite large, might feel easier when installed but using my hands it takes a bit of force.
-
JakefromStateFarm
> 3 dayWell built, solid. Mounting hardware included is sufficient. Would purchase again
-
Jinny Kimball
> 3 dayWe had a very large , heavy cedar closet to move , took four men to tip it on its side to add wheels to the bottom. It’s 9 feet long , we used eight wheels 2 inch height. Worked fantastic ! Now to clean behind it or rearrange anything it is easily pushed out ! Definitely heavy duty and came with screws and screwdriver . Worked absolutely perfect !!
-
Kylie Cronin
> 3 dayThese casters are called heavy duty with a load capacity that should have far exceeded the loads on the cart I attached them to, but the bearings are not made for those loads.
-
V.H.
> 3 dayVery pleased with them. I put them on a welder weighting 1500lb and they hold up good. Really recommend them
-
tim
> 3 dayI put 4 of these on my anvil stand--they seem tough enough to take the abuse-
-
Ronald Griffin
> 3 dayWorked great table rolls easily