TEMO Carbide Downcut Inlay Router Bit 1/32 Inch Diameter

using these bit for guitar inlay work.

Junky bit. Get what you paid for, I guess.

Very smooth cuts

This is a great set of bits, perfectly graduated for inlay work. The spiral downcut leaves a beautifully smooth bottom & Plunges like butter. These are solid carbide bits and work best at high speed with a slow feed rate. I have paid $30 for a single bit, so this set is a real value.

This bit does what I need it to do. You must be careful to not overload the pressure when cutting.

Well made at a good price. Thats about all I ask for out of a product.

wish I would have paid more attention to how short the cutting area was

Great Bit!!! For the money you can’t beat it. You have to be mindful of DOC and feed rates but it’s a 1/16” bit. I bought two more

I purchased two of these bits and both of them broke just after a couple of uses.

These are great bits. Just remember the rules of routing with fine bits. 1. Never cut deeper then the diameter of the cutter. The cutter not the shaft. 2. Dont move faster then the cutter can cut. If you violate these rules then fine detail bits of any brand will break.