Thermaltake V-Tubler PETG Tube 16mm (5/8) OD 1000mm 4-pack

They came in their individual plastic bags but a couple still managed to have some nice scratches and marks. I managed to make my bends where they wouldnt show. For the price I would definitely buy again

I little smaller then the same size tubing from Monsoon (I use Monsoon fittings) but Monsoon fitting comes with 2 sets of O-rimgs so no issues.

Best Petg

I was working on my first time hard tubing project. after some experiment with 90, 45 , 180 bends. I started to use this tube for my setup. I found it inconceivably easy to bend. It fits with the barrow 16mm hard tube fittings well, one time setup no leak..

Soak your insert in pure olive oil before you put it in the tube and heat the tube. That tube compresses the insert, no lubrication and you will not be able to pull your insert out! I tried some spray oil, but it contained water and fogged up the inside of the tube. Pure olive oil has 0% water, thus, no fogging. Also you can mark where to bend your tubes on the insert with a pencil mark. Just rub off the pencil mark easily.

Super

It’s good Quality PETG tubing I will definitely be using this from now on.

As others have mentioned, the tubes are not separated frim each other for shipping, so prepare for scratches. However, due to their low price, they were perfect for me because Im new and expected to fail a lot of bends.

Worked out great, and price was more reasonable than some other brands that were available and half the tubing. Pipe was very easy to bend, as long as you dont use a too high temp you are fine. You are able to reheat a tube if it did not turn out right, but you have to be careful as you can warp your bend even more.

Excellent and affordable tubing. PETG will require some careful heating and bending, but the end product is worth it. I find no tears or discoloration on bending/heating and the tubes look excellent in my rig!