Timorn L R Shoulder Button with Flex Cable Repair Parts for 3DS Left Right Shoulder Button (2 Sets)

Works just like new and easy to install.

Both arrived in one piece. Thought I should order two in case one of them got broken in the delivery but didn’t need two for now. Instaled both shoulder buttons on my wife’s Ocarina of Tine special edition OG 3DS, it works perfectly!

I was working on a heat damaged 3DS; the old ones were stuck to the shell with the adhesivr foam pads from the factory (which had turned all goopy from heat) and they tore. These feel nice and clicky, dropped right in place; no trimming or modification needed, and they work perfectly.

Yes ! My sons original Zelda black and gold 3DS works again. These are excellent very easy to replace but test your system before screwing back in all those crazy little things . We got qn extra one now for when it goes bad again which is highly likely its notorious foe this model. The only issue we had is the trigger ribbon closes to where you fold the back plate back on hardly has enough slack . This isnt the products fault but Nintendos weird design choice. That ribbon pops free very easy thats why I say test that puppy before ya screw it back together.

My kids have worn out the buttons on both of their DS. I found these and decided to give it a try. Install took less than 10 mins and works perfectly.

The switches are quality and have no issues at all. Overall an extremely easy replacement just make sure you order the correct cables for your 3DS model, I was looking at this one for my 2DS and another one for my NN3DS XL and it got a bit confusing since the details are on the bottom of the page, so make sure you double or triple check.

I got these and also a replacement back that had the switches included. The ones that came with the back are way better than these. The solder joints fall apart if you look at them (or when attempting to connect them to the system board with the snap on connectors.)

Came quickly, good that it came with 2 pairs because they rip EAZY Screw them onto the top screen first then clip them into the bottom or you can rip them as I did doing the opposite the first time. If the piece on the bottom breaks off into your ds you can pop it out with an xacto knife. Hard to mess this up, I did it in a few minutes without instructions or anything Nintendo knew you’d be doing this later

Works like its supposed to

fast shipping, mine came with 2 sets and works fine for my old 1st gen 3DS