Uniden BC-UTGC GPS USB Cable for use with BCD325P2 Handheld TrunkTracker V Scanner, SDS100 True I/Q Digital Handheld Scanner and BC-GPSK Serial GPS Receiver

Works as expected with GPS puck. The only design issue I have with it is the USB Mini cord could be longer when using in vehicle. The length isnt quite long enough to allow for much variation in placement of scanner. Might add an extension of some sort to take the stress off the cable when in the mount Im using.

Fit Uniden SDS100 scanner with BR-355S4 GPS. Makes it really nice traveling with scanner.

Used it on a trip. Repeatedly received a USB low voltage error message. I had to wiggle the plug that goes into the scanner for it to come back on. I checked it with another plug and work with no issues.

Not sure why this was needed. A USB cable is just as well to use. Vendor was great, delivery and return. Just don’t get the purpose of this product unless you need the round connector.

Worked perfect for hooking up a gps puck to my sds100 scanner.

No muss, no fuss. Plug and play. Works as expected.

Worked for about a month, then started failing and may have caused the control board in my radio to fail. Maybe just a bad unit, but cant recommend at this point. Problem started with low serial bus voltage message while in use. Disconnected GPS puck and message still there. Figured it out too late to save the $800 (after upgrades) radio.

Using one of these late model scanners without a GPS makes the scanner worthless without extensive programming. With the GPS and the connecting cable, you can ride from coast to coast and the scanner will change frequencies as you drive along. By all means, use a GPS.

Ok

Plug and play set the baud rate to 4800 and let the GPS communicate with the scanner. Works seamlessly.