Vacuum Bare Surface Canister Floor Brush, Compatible with Kenmore

I love my Kenmore Magic Blue. Unfortunately, the attachment for the floor had to be replaced and there wasnt one anymore. Kenmore stopped making it. This product does its job but not as well as the original Kenmore attachment. Its width is smaller -- 9 vs. 11. Unlike other reviewers, this didnt scratch the hardwood floor. In fact, it was very smooth when I used it. But because it doesnt have tiny wheels like the original, it tends to come off of the floor unless you have close attention when you are vacuuming and make sure its flush against the floor. As for the hole, this product came with two holes. My Magic Blue requires the hole to be on the left side if you were to look down on it in a vacuum position. The holes on the product rotated to fit my vacuum cleaner. The diameter of the wand on my vaccum is 1-1/4. It fit perfectly. What would make this perfect is wheels and wider size. But if the wheels cant be installed, then the company should consider making it wider. On the other hand, this smaller attachment did allow me to vacuum some small areas that I couldnt get to before.

I purchased this with the hope that I could use easily, while it fits fine the issue is that it is really not for the model I have. It cannot suction 100% as the hole is at an odd angle and it does not swivel so I actually had to turn the hose in the opposite direction for it to be flat on the floor to halfway suction. Not worth it for my cleaning purpose

It fits my Kenmore vacuum and it works better than the floor brush that came with my machine.

While it fits my Kenmore vacuum cleaner perfectly, I noticed that the height of the brushes keeps it a bit higher off the floor than I think the original floor brush did. Since I threw out the original, I cant compare them, so this is simply based on my memory (I could be wrong). But based on this I would give it only 4-stars - it does work well, but on hardwood floors I would like it to be a bit closer to the surface. NOT a big problem, just a preference.

Love this piece

The bristles are a bit too short and for the price I feel like it shouldve been perfect and these pieces seem to disappear often and as I run a cleaning company I order quite a bit because they do fit on most vacuum poles

The suction just isn’t the same. My vacuum gets more than it’s fair share of work so I know the angle ir takes to get the best suction. My feeling is that the bristles on this brush just aren’t long enough making the angle just odd enough that the suction sucks.

The brush is good but the swivel angle is poor. I like one that turns 90 degrees.

The slot hole that the vacuum cleaner tube goes into is in the wrong place. it is on the bottom with the angle of the brush is pointing down when attached? You cannot snap in hole and vacuum upright? Very strange, someone in China mixed that up.

This item was just as described and fit my Kenmore vacuum.