VSDISPLAY HD-MI DVI VGA Audio LCD Controller Board for 17 17 inch M170ETN01 1 WYD170SKD 01 LVDS 30 PIN LCD Display, for Mod Machine ( m170etn011 m170etn01.1 M170QGBN30-01B CD170A54-01 )

Im sure I just got a defective one, but mine caused some digital interference in the form of random white lines showing and disappearing all over the screen

Got exactly what I needed

Worked perfectly for modding the Gen 3 A1up Marvel Superheroes. Aspect ratio is correct and no cropping on the lower part of the screen.

Also there was no instructions, although its fairly straightforward there is a couple of buttons on the device that would have been really good to know, and also there is a way to change the volume that is mandatory or else your stuff is going to be too quiet. My biggest complaint is that I found this same circuit board on ebay, or Allie express, for $8 after shipping. Sure here youll get the Amazon guarantee but is it really worth another $20 for that guarantee? Probably not. If youre not on a budget this thing is definitely fine and it does what it advertises quite well. If there is latency, its hardly perceptible and I game at 4K 165 hertz.

First, I had a problem with the board I got from the seller Shenzhen Weisi Electronics Co. Ltd and they went beyond to help me fix the problem including sending replacement boards. Thumbs up to them! Thank you! What I saw was a bunch of small horizontal lines throughout the picture, moving around very fast. I mounted the board in several spots in my Arcade1up case, with to no avail. After a lot of diagnostics, my issue ended up being an insufficient ground/earth problem with the factory grounding strap not being enough for the LCD controller. After making sure to mount plenty of adhesive hook/loop as an insulator behind the controller (see blue arrow in picture) which is NOT optional. If you do not insulate the back of the LCD controller from the monitor case, it will not work/power up. Once insulated, youll need a couple small fine threaded screws to add the additional ground/earth connections needed (see green arrows in picture). I used computer screw and they were perfect! Once the ground/earth screws were added, the display is interference/artifact free! Grounding menthods are only slight touched on in many Arcade1up retropie build articles, but its VERY important. Hopefully my painful experience helps someone. Again, Shenzhen Weisi Electronics Co. Ltd bent over backwards to help me out, great seller!

If you want to mod your Arcade 1up cabinet this is the best part !

Installed it on my arcade 1up mod and there is a black bar that runs across the bottom of the screen. And it never goes away

Just leaving a note to say that this board worked terrific with my mod. Wave 3 Arcade1Up Marvel Super Heroes running without the cutoff - easy install / great packaging. Thanks!

Works great on Gen 3 popular branded cabs

I was skeptical, reading up on reddit about the lack of working controller for the gen3 lcds, but this does work with no problems. Still have to figure out the power on/off for the entire setup though.