Whiteside Router Bits 1376B Bowl and Tray Bit with 1/4-Inch Radius 1-1/4-Inch Cutting Diameter and 1/2-Inch Cutting Length
-
LJZ
> 3 dayHollowed out a fancy double bowl with bit. Worked well
-
Durwood Johnson
> 3 dayI uses this product to cut an indention into a serving tray.
-
Timothy Rau
> 3 dayUsed it to make some shallow cavities in charcuterie boards. Crisp cuts and leaves a flat smooth surface under the bit.
-
mICHAEL
> 3 dayNot disappointed with the quality Ive come to expect from bits from Whiteside bits.
-
K B
> 3 dayLove this bit. Very stable and easy to manage in my router table. Makes a nice flat surface, doesn’t burn or chip out. At first I tried the 3/4” bowl bit but it was frustrating because the flat spot was too small. This has a nice large flat spot.
-
Mike G.
> 3 dayUsed it yesterday to rough out a tray I was making out of Padauk. It replaces an old Whiteside bit that has lasted a long time....
-
Jason Palmer
> 3 dayGreat
-
Paul T Clark
Greater than one weekIf you are making a tray this is a good product. It is easy to use and after you route the outside just go over the inside and it will be flat. I only had to do very little sanding after using the product.
-
Carl Slye
Greater than one weekThe bit was sharp and ran smoothly.
-
cje118
> 3 dayGreat bit and at a better price than many of its competitors. This bit is large and best used after removing material with a drill press. It leaves a clean surface which requires only minor sanding.
