Whiteside Router Bits 2305 Chamfer Bit with 45-Degree 5/8-Inch Cutting Length

All the quality one expects in a Whiteside Bit.

So far I have only used this bit on quarter-inch thick walnut, but it did a great job. Little or no vibration, smooth cuts, dead-on thirty degrees.

Love these bits

Cuts like butter even through the hardest maple.

Strong, sharp. Great bits.

Exactly and described and the same great quality Whiteside always delivers. I have never been disappointed with this companys products.

Whiteside... Not a better brand!

This was my first attempt at an edge profile, though Ive routed square dados before. Was nervous at first but got the hang of it quickly. I found that I did not need to support the router base other than resting on the workpiece. I used carpet tape and secured each piece with plenty of space around it, just held the router by hand. The bit pulled the router along the edge of the piece like it had a magnet. It tightly whipped around the corner which was wild and amazing. Edges came out clean and tight with virtually no tearing (Id just brush a few fibers away with my fingers.) See photos. Bit worked great.

I’ve never been disappointed in Whiteside router bits. Always my first choice.

I built bunk beds out of two-by-fours. Using this bit to chamfer the edges made it look a lot nicer. The bit is super sharp and made lots of cuts very cleanly and with honest long chips, not dust. No sanding! Love my Whiteside bits