Wolfride Rabbet Router Bit Bearings Replacement Bearings for Router Bits | Inner Dia. 3/16” & Outer Dia. 3/8, 1/2, 5/8, 3/4, 7/8, 1, 1-1/8

Purchased these to use as a balancing point for lawn mower blades. Seems to work fine so far.

Helped me get through a project. These bearings are not all the same brand. It is a mix of brands. Some of them were decent quality, and some of them were not that great. Would give it a 3.5 star if I could.

Duraron menos que un merengue en la puerta de un colegio

first use I failed to provide a backer board when routing a small rabbet in a thin piece of plywood and the bit gauged too deep when the bearing flexed slightly... MY BAD!!! great selection of sizes, lots of attachment screws, good accessory for my router

Bottom bearing fits all my 1/4 inch router bits

Bought these last week for a special project I have going along with some bits. Less than six inches of work and the bearing I was using from the set flew apart. Happened to have the same size on an old bit I have and used it instead. Trimmed 40 feet of facia board without further trouble. Id give them no stars but looks like I might have to give them one. Am sure disappointed with the Wolfride bearings and am returning them for something else!

These perform well enough for me. I use them for routing binding channel for guitars where even little mistakes are not acceptable. They work in that situation just fine.

I am happy with this product. It is nice to have spare guide bearings for guided router bits. They dont last forever and keeping a stock is handy.

First bearing self destructed in less than 5 minutes. Installed an OEM, its working fine. Have not tried the others.

Excelente producto