

















Xenocam 12 Pack 2.1mm x 5.5mm Male CCTV Camera DC Power Adapter Connector
-
Mr Techie
> 3 dayWell made and works well!
-
Frank - Jen - Kaleigh
> 3 dayWorks great just as described.
-
Tim P.
> 3 dayMakes changing out cameras easy. Delivered as promised.
-
M. Cogan
> 3 dayThese worked for me.
-
Robin
Greater than one weekwork great
-
Techn Moto
Greater than one weekdoes what it is intended to do. Cheaply made but gets the job done.
-
Tyler B
> 3 dayThe connectors looked like a great idea with the screw down wire terminals which would allow a bigger gauge wire to be used with the 2.1 x 5.5 mm plug. Unfortunately the quality of the clamp and the plug is not very good. I connected using 18 gauge copper zip cord and the screw terminals would not consistently grab the bare wire tightly enough to hold as well as a soldered joint. When tightened down as much as reasonable for the screw size the wire could still be pulled out of one or both terminals. Part of this is due to the design, the clamping surface is very small and smooth and the short design of the plug places the strain too close to the clamp. If a person plans to use these for a purpose where there is zero pull or movement and then covers wire and connector with a continuous piece of heat shrink tubing they may work OK. If you anticipate any pull or movement of the wire it would be best to solder the wire in as well or rather use a solder-type plug with built in strain relief device. Im going back to using the soldered type fitting.
-
Charles M.
> 3 daySimply the easiest way to add a 12v barrel connector to the end of a wire.
-
James E.
> 3 daythis is the second pack I have used and I love them to be able to connect the power end at the DVR to my multi unit power supply ,I can use number 18 wire from them to my power supply.
-
Carl Jr
> 3 dayI installed security cameras at a remote building, powering them up with a solar-charged 12 volt battery bank. The inverter I was using was extremely loud and I found it annoying. Using these connectors, I was able to remove the need for the transformer and connected the cameras directly to the 12 volt power source. Easy to install and work just great!!