Yakamoz 2Pcs 1/4 Shank Top and Bottom Bearing Guide Flush Trim Pattern Router Bit Set Woodworking Cutter Tool with 10 Pcs Top Mounted Replacement Bearings

Pretty trash. The bits aren’t sharp enough to make a dint in 40k minis. The handle does what it should, so I just got some higher quality bits from Bunnings.

DO NOT BUY! The picture tells you why but let me explain. I sometimes need to shave 1/8 of the sides of a guitar body. So stupid me, I went cheep. Not noticing the other bent bit complaints a few others had. Got then and they looked Ok. A few months later I chucked one up in my trusty Makita router and spun it around by hand. Still looked OK. Turned it on and it immediately started wobbling at least a 1/4. Then bent, hit the guitar body and went flying out of the router. Fortunate no luthiers (me) were hurt. Did damage the router chuck and the guitar. :( So while most folks get good ones, the manufactures quality control must miss a few out-of-balance ones. Making then to risky to buy.

Now I know why they send extra bearings Bearing fell apart after minimal use Be careful and check bearings often Would not buy again

As described. Received delivery promptly. Works good, wasnt expecting it to be this good and have different size drill bits. Glad I purchased this instead of the $50 one from the hardware store that doesnt sell the drill bits.

clean finish

Ive used this once to drill holes into 2 copies of super smash bros for nintendo 3ds... if you need a product that is appropriate for that very specific task, look no further. Bits were quite sharp, and it was easy to use accurately.

I used these to route mdf using a template guide. On first use, the ball bearing literally fell apart and flew off, leave a huge gouge into my template and desired workpiece. With that said, the cutting edges are as good as most premium router bits. Paint is atrocious and flakes off. these are quite wide, so youll want to have your router set to its highest rpm (if its variable) as the bit will want to jump and skip if the router is spinning too slow.

The drill doesn’t even drill through my 2mm work piece, pretty disappointed

Its accurate but after the first use the yellow color has been peeled off and I can see the cut is not sharp and smooth.

Drill bits simply arent sharp enough even for 40K plastic