Zeberoxyz 10pcs Copper Buckle,Wire Cable Connector,Durable Wire Cable Terminal Lightweight Compact Terminal Accessory for 3D Printer Parts (Copper Buckle)
-
MoJo18
> 24 hourWorked good for me. I used an ratcheting electrical crimping tool to crimp my belt. I found that facing the belt teeth towards each other eliminates any slipping, but that only works on certain setups. Worked on my anycubic cobra plus
-
benedict benedict
> 24 hourUsed on the new ENDER2 Pro
-
Manarchany
> 24 hourIm using the buckles to replace the belt on my Ender 3. They worked well and were easy to install.
-
Dan
> 24 hourJust make sure to squeeze them tight and they will hold. I’ve never had one close like they do in the pictures but I squeeze the shenanigans out of them and it works just fine. Used on the belts for my CR10v3 printer belts.
-
Dr. V. Fries
> 24 hourExactly what I needed.
-
Andre C.
> 24 hourWorks as advertised
-
eyal
> 24 hour1
-
Ben Layne-Gordon
> 24 hourGood luck making these work. When you crank down enough to get them tight they flatten out.
-
Seth Robins
> 24 hourReally struggled with getting this to work correctly :(
-
menehune808
> 24 hourI was hoping that there was going to be some extra material, but not even a cm of extra for my ender 5 plus. I expect it wont last for long, but at least I can continue printing for now.
