ZHUBANG Auto Clips Car Wire Harness Routing Assortment Universal 155 PCS Retainer Car Clips Contains 10 Different Sizes Replacement Parts for Honda GM MazdaAA Ford GMC Chevrolet

The kit has a nice array of wire loom press in clamps. Worked great on my 06 dodge truck and 79 cj7 jeep.

Good product and lots of fixings for the money, would by again but with this many parts included will not need to for some time.

The item was exactly what I wanted and needed for my project . I was disappointed that it was wasn’t shipped until the date suggested that I would have it by . I needed it quickly and ordered it because of the listed delivery date listed but not did get it until two days later .

Its exactly what I wanted for my 75 Jeep wiring

I bought these to use to hold the injector wiring harness up on a C7 caterpillar. Worked fine. I dont think I will use a lot of the other sizes but was inexpensive enough.

I did an engine swap on a 2003 Altima and also needed to replace a partial wiring harness and several individual wires. These ties worked good for what I needed to finish this job.

There is nothing to dislike about it.

Very prompt delivery, and the parts work exactly how they should. will definitely order again once I come close to running out.

I finally decided to upgrade some battery maintainer wiring in the cars. Since Covid sort of exacerbated battery issues in a couple of the normally daily-driver cars, Ive been leaving them connected to battery maintainers as the summer-only cars have been during hibernation seasons. some extended harness fabrication, some accordion sleeve, and these clips make the permanent harness installation look as good as any factory wiring. Now the charging plugs sit at the base of the windscreens under the edge of the hood, and are nice and secure with these clips. Do look carefully at the dimensions for these. They give the details for the mounting pins, but not for the size of tubing or bundle that will fit. Fortunately there are several sizes and types. The smallest clamp is a little generous for the 1/4 not-split tubing I used, but still looks and works OK.

Good selection