24 Pieces Brass Rods Round Solid Brass Stock Pin Assorted Diameter 1.5-8 mm for 100 mm Length Brass Rod for Drift Punches Various Shaft DIY Craft Model Plane Ship Cars Knife Handles
-
Jim Russett
> 24 hourUsed these to attach scales to knives I was making. Its nice to have several sizes. I was able to make 3 pins from one rod.
-
Elyssa Walsh
> 24 hourI needed this for a project I was building. It worked as well as I had hoped. I was able to cut it down to the exact size to make precision pieces with non precision tools.
-
José Pedraza
> 24 hourSo amazing
-
Tristian Renner
> 24 hourLook Good Quality i dont currently have any calipers to check the sizing. But the 5mm fit my knife blanks well & was easier than finding them on their own. I didnt like the mosaic pins that woodcraft had in the correct size for the knifes. The solid Brass just looks much better to me. Will have to find something to do with the other sizes but they should come in handy. They are not Magnetic so i do believe they are actually brass. One star off for the packaging it was in a soft envelope so the plastic storage case for them was cracked pretty bad, the case would have been nice to have intact.
-
Jorge
> 24 hourthis is nice un-bent stock in all sizes. i usually get stock from a different supplier and the pieces are never straight. These are perfectly straight and exactly 100mm as advertised. The diameter is also accurate according to the description. Will order again soon.
-
Ben
> 24 hourI used these for pins in a knife handle. Worked well.
-
R. Patton
> 24 hourGreat product.
-
Kris
> 24 hourNeeded some brass pins for a woodworking project. Found this kit and went for it, plenty on hand for future projects. Only thing Id change is more of the medium sizes and less of the smaller sizes. The smaller ones are just bit to small for my needs.
-
Icebryce
> 24 hourDont think I would have a use for this. Was lookin for brass drift punches
-
Randall
> 24 hourI use these for working stones into jewelery. Iuse them for dop sticks. A drop of cynoacrlic glue on the end, stick it to the stone, work the stone, then apply heat to the rod and stone fall off. Use a knife to remove any ca left on the stone and your done. I will buy more it i need them. The assorted sizes are great for different size stones. A different use for a good product.