5 Inch 8 Hole Hook and Loop Sander Pad For DeWalt , Makita , Porter Cable Orbital Sander - Fits DW421/K, DW423/K & BO5010, BO5030K, BO5031K, BO5041K & 390K 382 343 Replacement Sander Pad

Used to have to replace these pads every couple of months when my cabinet shop was busy. Now that Im retired, my hobby work is a lot less demanding. These fit perfectly on both my DeWalt and Porter-Cable sanders. The hooks grab the sandpaper firmly and therefore fulfill their sole purpose just fine. Will buy again if I have to. Price for two is less than price for one DeWalt branded replacement.

It’s where weak last only for a while damaging the screws holes

the holes didnt line up. had to drill them out a little

I know, I know it says it will fit a Makita B05010. Not so. Oh, its close. So close that you might be tempted to try to make it fit. The first screw - fine. The second is where you get that feeling, but with a little persuasion you can get it to go. The third and last screw........ well go ahead and try. It will go in..... on the diagonal. Unless you enjoy cross threading and damaging your sander, I would just buy something else. I ended up very carefully re-drilling the hole and got it to work just because it was easier than the return hassle. I figured if I ruined it, Id be done with it. These pads seem to work fine, Just not on a Makita B05010.

Me ha gustado bastante, esta de acuerdo con la descripción

did not fit Bosch 05010 as it claimed, had to add washers between sanding pad and sander to avoid screws from jamming sander and screw holes were not in exact correct place, was difficult to get installed without cross threading due to hole pattern in pad being smaller than screw pattern on sander.

As described

does what its supposed to.

Screws burned through the holes and pads flew off within 15 minutes of use. Super cheap material

works perfect, easy install. thank you.