5-Inch Hook and Loop Backing Pad Replacement Sander Pad for Ryobi RS290, RS280, P411, Milwaukee 6021-21 & 6034-21, Craftsman 315.112170,315.116940

The original ryobi blue had a indentation in the center for the bolt that the spindle plate spins on This one does not have that. So I will have to grind one in the center of the new one to accommodate that center bolt to prevent heat from friction.. See pics

This fit my old ryobi orbital sander. It was about $3 cheaper and I feel like it may be made better. Only time will tell

Perfect fit, great value for money, very easy to install. My orbital sander works like its new. The sanding pads fits firmer then the original pad.

Before purchasing I compared the description and measurements with my sander and found it was a match. I think my old backing pad is a bit softer than this one, but that may just be due to wear over time. This pad works well, holds the disks well.

For perfect on my Ryobi ROS. Works like new again.

The item was good quality and in the end , adaptable to what I was looking to accomplish.

Perfect fit.

The pads are great for my sander. I have a lot of sanding to do. Gotta get sanding....

Put my Milwaukee 5 sander adheres great.

Its works however it did not have the securing notch in the center, but works great!