5Aplusreprap 12Pcs Adjustable 3D Printer Ender 3 Pro Glass Clips Clamps Compatible with Ender 3/3 Pro/V2/3S, Ender 5/Pro, CR-20 PRO, CR10/10S Pro, 3D Printer Heat Bed Clips

The design and look is pretty cool. The durability is nice and acceptable. There is no guide on how to put this all together on the bed, but the little spacer rings go between the red adjuster and the bottom of the bed. With it all put together, I lost 2.5mm of Z height.

Low profile, keeps my glass in place

For some reason I could not level the back left corner of my Ender 3 neo. Ended up snapping a screw so I order this and with the new springs I had no issues at all leveling the bed. Finally I’m able to start printing!

One was stripped other than that the others work good

The spring steel clips that come with this kit are similar to the two provided by the OEM for my 3d printer. The original clips loosened up and allowed the glass bed to move around creating very interesting 3d prints. I suppose adding a few more clips around the all four edges would solve the problem but this screw clamp looked like a better solution. In the end, I used both the clamps and the screws in order to secure the glass bed. The screw clamps work well on the front and back of the bed. The clips work well on the sides where there is less clearance. Note that the screw clamps extend downwards quite a bit so when installing, move the bed all the way forward and backwards to be sure the clamps dont hit anything on the frame. The clips are unremarkable, but the screw clamps are nicely machined and finished. I applied them with the screw positioned under the bed. The springs keep the screws from backing off due to vibration. I havent used the printer long enough to see if this is sufficient to keep the clamps secured. I will be checking on the clamps from time to time. Overall the combination of clips and clamps worked well for me.

I used these on the glass bed upgrade for a Creality CR-10 Smart Pro and they not only look very nice, they also do a great job of holding the glass bed in place. At 6cm from either side along the front/rear edges, they do not interfere with the self-leveling feature or any print jobs. I highly recommend!!

They are alot better then clips

Works well, very simple to install, and you dont notice them. When auto leveling, the extruder completely clears the clamps. Couldnt ask for a better product!

The only problem I have is that the black clamps sit a little high even when tighten down. I’ve noticed this with my printer so it might be different per person. But I noticed depending on the print the extruder will run into the clamp and jam it’s self. Again largely depends on what your printing.

I say, not so great for glass beds, b/c of the screw that comes down after tightening the part. I know I should have it upside down but I do not b/c of the formation of my bed to gantry ratio. Still, all in all, good parts.