













5Aplusreprap 12Pcs Adjustable 3D Printer Ender 3 Pro Glass Clips Clamps Compatible with Ender 3/3 Pro/V2/3S, Ender 5/Pro, CR-20 PRO, CR10/10S Pro, 3D Printer Heat Bed Clips
-
John G.
> 24 hourThese work better than the clamps that came with the glass bed, easy to install and easy to remove. Holds the glass bed in place without the popping off as the steel clamps would do after half way through a print. Recommend these to hold the print bed in place.
-
Dillon Stehr
> 24 hourThey fit perfect and add more adjustability of bed surface
-
M. Caron
> 24 hourI have them on all 3 of my printers. They hold much better than the binder clips and have a lower profile. I highly recommend this reasonably priced upgrade.
-
Pitters
> 24 hourLow profile, keeps my glass in place
-
Tonja Davis
> 24 hourThe low profile of these clamps mean they dont cover as much space as the standard clamps. The knobs mean installation and removal are a breeze. The small size mean you can attach these on the sides of the bed without hitting the uprights. I have these on both printers and I have yet to find anything about them I dont like. These are amazing little clamps!!
-
Thew
> 24 hourThese arent a lot smaller than binder clips but the difference is quite noticeable: no more snags on fan duct similar to thing #2814127 = no more launched clips = no more bed slippage = fewer failed prints. Does take a bit longer to remove/replace glass bed & felt expensive to purchase up front, but Ive spent just a much on binder clips over the past few years and probably have already broken even on filament costs just from fewer failed prints. Ive put these on 2 of our 3 printers now. Only reason not all 3 is the magnetic bed in the third has never presented a single reason to consider anything else.
-
Jason Griggs
> 24 hourWork great on my ender 3 v2. Recommend
-
Bryan
> 24 hourThey are alot better then clips
-
Ridesshadow
> 24 hourThe wheels & springs installed on my Ender 3V2 very easily. The bed seems to maintain its “Levelness” much better than with the wheels & springs that come with the 3V2. When I was a 3D printing newbie I felt this upgrade was really needed. What I mostly needed was experience with 3D printing. Would I buy this again? Yes! Can I level my bed and have successful 3D prints without it? Also Yes. The clamps that come with the bed are nice but way overkill. No one ever tells you to remove the bed to remove a stuck printed part. The spring clamps that come with the 3V2 are easy to remove & replace. And after removing the stuck part that has bred printed, the bed pretty much goes back on in its same place without placing undo stress on the bed by prying on it. I like the bed clamps, they work as they should, but I see them now as a nice perk, not a necessity.
-
(◕દ◕)
> 24 hourThese dont clear the extruder fan on the left side nor the heater block in the back so I can only clip on the right side. But recommended, get something shorter