5PCS A4 FEP Film for Elegoo Saturn 2, Saturn S, Saturn 8K, Anycubic M3 Premium, Mono X 6K, Photon M3, M3 Plus, Phrozen Sonic Mighty 4K LCD 3D Printers, 210x300x0.15mm Resin Vat FEP Film Replacement

Everyone needs some replacement FEP film eventually. Im using this in a Saturn printer and it fits perfectly. The film itself seems like its very high-quality material that will last a while. My favorite part is the 5 FEP films in this pack, though. Its always a pain to remember if you have any extra FEP or if you already went through your last one. With 5, you rarely have to worry about that... and you at least have enough warning to go ahead and order some more. Most FEP replacements come with 2 films for the same price as this. So, really, you might as well give this one a try!

Easy to use Fep film. Quality made. Can be trimmed to your needs and works great with no sticking issues.

Had a few sticks on the one im running currently. None really in the same spots and not every run so ive definitely seen worse. Price wise if you need to save money id say its worth it, but personally id just save up a little more and get your printers brand or current favorite fep.

more flexible and more clear than original manufacturers, also half the price.. printing down to 8k

I purchased another brand of these a few months back here on amazon that also shipped via prime and the packaging left a lot to be desired. I had planned to use one of the fep sheets as a screen protector but the crease was so bad it didnt wanna lay flat even when I tried taping it down tight. The creases arent as much of an issue for use as a normal FEP sheet since the mounting and tensioning process pulls all but the worst creases out so you could say the product worked as advertised. This time when I ordered I hoped things had changed in packaging department but again it was folded in half and shoved into my mailbox. I dont blame amazon for this since the packaging itself can be creased on corners quite easily just by handling it. That said, these work fine for use as a FEP but Im knocking a star off for those of us who want to use them as a screen protector under the FEP as well.

You should always take care to keep from damaging the FEP release film, but inevitably it’s going to get scratched up or even torn. So treat it like a consumable - keep a stock like this around and replace the film on a regular basis. Resin printing has a lot of variables - it’s always a good thing to reduce them to a minimum.

5 FEP sheets for this price is a no brainer. I cannot say they work perfect but once you learn to tension properly then calibrate lift speeds properly you will have no issues with most FEP sheets so save some money by learning how to tension/calibrate rather than having to be stuck with expensive FEPs.

At 210 x 300 mm, these FEP sheets are way too large for my little resin printer, but theyre easy to cut in half with sharp scissors or a knife, so I end up getting 10 sheets for a pretty reasonable price. They are exceptionally clear - great for just about any resin printer. Installation is easy - just follow the instructions for your printer and be careful to get the film nice and tight. Also, make sure you remove the protective film from both sides. Thats actually the toughest part of installation for me!

My colder environment leads to prints that stick hard and FEP damage at an accelerated rate. I change FEPs a lot more frequently than most. The nice thing about these larger FEP films is if you run multiple printers theyll work for a larger Saturn and its exactly double the size of my Mars 2 so I can cut a sheet in half and get two FEPs for my smaller printer as well.

This works with my husbands Saturn. It has no issues and works just like the other films he has used