



















American Technology Components Single SPST On-Off Switch with Bezel, 12-Volt, for RV, Trailer, Camper (Black)
-
Jeff Haskin
> 3 dayEasy replacement for existing switch in my RV
-
GnshpCSO
> 3 dayQuality switch, works as advertised
-
Scott M
> 3 dayLooks to be direct replacement of the switches in my RV
-
Pronto
> 3 dayNice switch but as mentioned in another review, it was more work to install than I expected. It DOES require a rectangular hole for the body of the switch to fit recessed in the wall so the front cover to fit flush to the wall. More product photos in the ad would be very helpful. I bought 1 to try and it arrived in good condition and works just fine. I bought a 2nd one for another location but it arrived with a bent blade terminal as shown in the photo. I expect it to work fine once its straightened but wont know for sure until I get to that point. Overall ok but expect to figure out how to cut a rectangular hole.
-
Robert Kim
> 3 dayThis is a direct replacement of my light switch in the bedroom of my Grand Design RV. I bought two in case I have to replace it, again (this is my second order!)
-
Thomas D Jones
> 3 dayIf you are drilling a hole you have to drill it a little larger than you would like and the connectors are very small but it works well.
-
Precious Metz
> 3 daynot weather proof. i
-
Wendy Jacobson
> 3 dayIncomplete assembly 2 pieces of plastic no screws useless
-
Shopping Sheri
> 3 dayWould have been a great value for the money, but the materials used are cheap, one of the blades cracked off during installation... they are a very thin gauge of metal so they bend EXTREMELY easily. I did not handle this switch roughly during installation, in fact, I took great care because it is so lightweight and felt so cheap I was worried about it breaking. I purchased two, and was successful installing the second switch after learning how easily they bend/ break. Its a comfortable switch to operate, and looks good, just make sure youre prepared to be extremely gentle with it, and to cut a custom size hole, or create your own switch plate cover- it is way too small to install in an existing standard cut-out, and then be extremely gentle with it.
-
Roger A. Yeager
> 3 dayPerfect replacement for old switch