EPAX nFEP Film Sheet 200 x 140mm Thickness 0.125mm for E6/X1 and Other 5.5/6 inch UV Resin 3D Printers, Pack of 3 Films

Seems like less pulling force than FEP.

Perfect , no more bad prints.

This stuff works so much better than the regular fep sheets. Since having installed this I have not have a failed print due to it sticking to the fep, my fails are completely my fault now. Lol.

Great solution for my Phrozen Mini. Easy to install and trim with a sharp knife.

I tried this out on my Elegoo Mars and so far its ok. Im not wowed or astonished. It does the job. But I think Im still replacing it at about the same rate I was replacing regular FEP. Maybe my printers not high def enough or etc to show a difference, but with an Elegoo Mars, using Elegoo ABS-Like resin, so far its all the same.

film seems really good but my package came practically bent in half bending the films

First of all, this is a great product- Im not sure exactly WHAT it is, but its not FEP... Whatever it is, though- it works. And, works well. I have replaced the original FEP sheets in the machines I use for production with these. I DO have an EPAX X1 Printer, which I also really love, and of course I use the Non-FEP sheets in that. But, Its going in EVERY printer once I have a chance to do so. What makes it better?? Its hard to be objective in a review of a product like this, because there is no really easy way to measure what makes it better since there are so many variables in SLA printing. But, I have far fewer failures with this film caused by prints sticking to the FEP. It also seems to last longer between replacements. Now, the company. You cant ask for better customer service- They are prompt at replying to inquiries, knowledgable about their product, and willing to help customers. They are also very proactive when it comes to customer satisfaction- The last set of FEP sheets that I ordered had a mistake in it, they shipped only one sheet rather than three. I didnt catch the mistake- as I had just put them on a shelf to use later- but I got a letter from them, along with the missing sheets, explaining that they had made an error, and were correcting it! Thats what I call service.

After losing a few prints to resin sticking to the fep I switched to the Epax nonfep. This stuff works as advertised. I havent had a single failure due to the resin sticking since switching. It is also easier to install, it is more flexible than the standard fep. The fact that prints dont stick to it should increase its useful life also. Great product.

Im not scientifically minded enough to tell you the difference between this and standard fep sheets. I can tell you this stuff is worth every penny. Having tried dozens of other sheets, I have never been able to match the lifetime these sheets provide. Less failures. More printing. All while loading the build plates to the brim. I always come back to this product.

I bought a 3 pack of this earlier this year just to have on hand. I went to change out a vats nfep with the new stock but upon completion I held it up to the light and noticed 3 or 4 dark specks. They appear to be embedded in it as they dont reflect light on either side. Annoyed I went to change that one out with another one from the pack, unfortunately they all had the same flaws. $24 down the toilet. I never had this problem before with fep from various manufactures / resellers.