Firestik MKM2 Molded Side Mount with 18 ft. Fire-Flex Coax -W-Lugs

The mount itself is great. The cable was just the right length for my application. However, the eyelet for the cable was too small to fit over the stud on the mount. I ended up being forced to replace it with a larger one. Not a big deal for me, but some buyers may not be handy with a soldering iron.

Mounted cb antenna on body of Jeep. Worked out nicely. Only issue I had is the surface to the antenna it beveled slightly causing lean. I shimmed it with a washer.

Im using this because I wanted a high-gain antenna and the body panels on my Bronco are too tight to put coax thru for a front fender mount. May have to buy another one and co-phase them. Mounting point is just behind the door.

Works great

I bought these (2) for mounting my CB and Scanner Antennas without having to drill holes in the body of my truck. Theyre mounted on the back side of my truck bed tool box and they kept me from running a separate ground wire. Mated to the firestick purchased at the same time and hooked to the new Uniden sideband, I was able to obtain a 1 to 1 match on both channels 1 and 40. Easy to install, very clean look and Id buy them again. Thanks Amazon and Firestick!

Nothing

Most of the people in our off road trail group has these and were very pleased with the performance, installed very easily and quality was great. Would highly recommend.

This is mounted right above the drivers side tail light on a Jeep YJ. It looks factory clean and does a great job of getting a signal out. It seems really rugged with a 3 Firefly, getting caught on tree limbs and brush off road.

So far I’m giving it 5 stars. It was super easy to install. I used a step bit and light pressure to drill through my precious cherokee’s unibody. I put some heavy car wax around the mounting location to help prevent any moisture issues. The outer part has a thick rubber gasket so I’m not worried about moisture intrusion. Make sure the nylon spacer fits in the upper hole so the bolt doesn’t ground out on anything otherwise your radio won’t be able to receive or transmit anything. Use some threadlocker on the nuts and you’re done. I haven’t wired up my radio yet but I’ll be back to edit my review if the performance is anything less than 5 stars.

Good quality mount kit.