HOUSE TUNING Bar Clamps 2.25 inch -Pack 2, 2 1/4 inch Roll Bar Clamp Bracket,Led Light Mount Clamp,Roll Bar Mounting Brackets,Tube Light Mount for Light Bar (2.25 Clamp - Pack 2)

Worked great on my truck. thanks.

worked like they were supposed to. very happy

Used for lights on frame of DS650.

Bought these to hook up Lexin lx-s3 speakers to my vrod muscle. The diameter of the handlebar is 1.75 and your average motorcycle speakers dont come with brackets that big. These are very solid and hook on securely to the bike. Would highly recommend.

This item is very poor quality and anyone wanting a high quality clamp should look at an alternate brand. The tolerances are way off, so much that the two screws used to hold the cap are binding against the sidewall of the holes. Furthermore, the final inside diameter (when the screws are tight) is not symmetrical; therefore, causing an uneven clamping around the entire circumference of the clamp. The finish is not anodize or powder coat; thus these clamps will look terrible and begin to corrode within 4 months of install. No thanks.

Great bracket

Used these to mount a tool box to my 4wheeler rack. Worked like a charm. Use to use a similar product for mounting items on race car cages. This was exactly what I was looking for.

Perfect clamps for mounting these LED driving lights on my Vulcan 900 Cobra engine guard. Very well made, sturdy and clamp perfectly on the 1-1/2 bar using the included tough rubber inserts. Hardware is stainless and excellent quality. They should last for years. Very pleased for a $12 investment!

I bought these to mount a shovel and traction boards to my 2019 4Runner. The 2 size is a bit too large for the factory Toyota TRD roof racks rails. I tried using inner tube rubber to make up the difference but that did not work out. The next day I bought a piece of 2 round rubber hose from the plumbing dept , I cut some slices off to match the width of the clamps to make up the difference in size and it worked fantastic. I then drilled 2 holes in the traction boards, ran a 6 carriage bolt through the clamp and 2 boards and put a nut and a threaded knob on the outside to ensure that they would not loosen up on the road. The other side has rubber adaptors to hold circular tool handles and my shovel is secure. Good deal, Recommended highly. Well made with a low gloss black crinkle coat.

Stronger and better looking than I expected. I used these to relocate my front turn signals to the fork tubes on my motorcycle. at 1.5 (38.1mm) they are smaller than my 39mm fork tubes and I thought I might have to machine them to fit. By not using the included rubber pads, and tightening each side a little at a time, I achieved a perfect fit. If you want a high quality, great looking, sturdy P clamp, you wont be disappointed.