HOUSE TUNING Bar Clamps 2.25 inch -Pack 2, 2 1/4 inch Roll Bar Clamp Bracket,Led Light Mount Clamp,Roll Bar Mounting Brackets,Tube Light Mount for Light Bar (2.25 Clamp - Pack 2)
-
xaggie
> 3 dayThis item is very poor quality and anyone wanting a high quality clamp should look at an alternate brand. The tolerances are way off, so much that the two screws used to hold the cap are binding against the sidewall of the holes. Furthermore, the final inside diameter (when the screws are tight) is not symmetrical; therefore, causing an uneven clamping around the entire circumference of the clamp. The finish is not anodize or powder coat; thus these clamps will look terrible and begin to corrode within 4 months of install. No thanks.
-
Robert Richardson
> 3 dayGREAT MOUNT
-
Catptain Chris
> 3 daySimple nice quality
-
legle
> 3 dayPut this on my Tusk tire carrier/rear bumper on my rzr. I use it to hold my shovel and it fit pretty dang nicely. Well worth the money and would buy again
-
Brandon Chandler
> 3 dayGreat quality holder. I’m using them to harness some stuff on a bed rack. Surprisingly strong
-
FishOnTheLine
> 3 dayThese seemed ok, for the price, until I installed the second one. I was very careful and have 20 years experience installing 4x4 accessories but the hole stripped out the moment the second bolt went in. The aluminum is weak and the threads are easy to screw up in manufacturing I suppose. Too bad. $13 in the trash as its kinda hard to return things with the lock-downs going on around here.
-
Matt Heaston
> 3 dayAs expected
-
Tater840
Greater than one weekNice product for adding light bar
-
Stopher
> 3 dayNice fit and look great
-
Kyle Bedford
> 3 dayBought these to mount a LED light bar on my 4 wheeler. They work great holds the light perfectly still.
