K400S K-400S Diamond Original K400S Heavy Duty Hatchback/Trunk Mobile Mount - K400 Base with UHF Mount - 13.5 Feet of RG316 - PL259

Works great with my Diamond quad band antenna zero complaints nicest mount I have used

Looks good, and easy to install. You can see and feel the quality

I bought mine back in 2010 and been using it since then with the only problem is the small set screws that help hold it to the lip of the body of the car you use. The set screws started to round out so the Allen key wouldnt tighten them, so I bought 8 more but these are set screwws with a round head on them that uses a bigger Allen Key. The only problem then is with the new set screws you need more room on the inside of the jam since the head sticks out about a 1/8 of an inch. I have my mount on my Conversion Vans rear door and with the new set screws I can get it ready tight now. I also drilled a hole on the side of the base where my 4 foot FireStik mounts to for a better ground by adding a ground wire This mount is great because its easy to set up and transfer to a different vehicle if needed I would buy again if needed

Good quality

perfect mount for the Diamond antenna.

Very useful and very easy to install it, the built quality is solid and heavy duty.

I failed to find a location where I could use this mount of a Jeep TJ/LJ. While trying, I still appreciate the quality and adjustability.

I did not buy mine from Amazon. I bought it from HRO with a Diamond antenna. The mount however is very sturdy and easy to install and set up. Just take your time.

I cannot recommend this antenna mount as it is made now because it will not hold the antenna in a fixed position. I recently purchased a Diamond K400S as the recommended mount for a Diamond CR-8900A antenna. I planned on using my YAESU FT-8900R in the lower 10 and 6 meter bands which I have never used before. This was a 3,500 mile trip and unfortunately I was never able to use the radio. The antenna mount would not stay tightened. I didn’t get even 20 minutes from home before the mount started to wobble loose. After several attempts at tightening one of the axis screws, I gave up and removed the antenna. I notice that regardless how tight the axis screw is, there is still play/wobble in one of the axis (see photo). I wonder if this causes the screw to come lose in a short period of time. Note, it is not the trunk clamp wobbling. It is the axis even when screw is fully tightened. Eventually (in my case - 20 minutes), the antenna falls over because the screw comes lose and lets the axis turn freely. The CR-8900A antenna, made by the same manufacturer, specifically calls for this mount to be used. I think the mount is not stable enough for the weight of the heavy antenna. Right now, I can only use the mount when the car is stationary and I install the antenna. The antenna has to be removed to drive any distance. Although this will work in some cases, it is disappointing and does not qualify as a properly working product. Update: Dealers who sell the mount generally do not permit returns, so I emailed Diamond for support. There has been no response.

Very Happy Customer.