Wishlist(0)
520shoppy.com
Categories See All >

KINGPRINT DRV8825 Stepper Motor Driver Module with Heat Sink for 3D Printer Rrerap Ramps 1.4 A4988 (Pack of 5pcs)

(152 Reviews)
Price
$16.99
Quantity
(10000 available )
Total Price
Share
30 Ratings
12
8
3
1
6
Reviews

  • Kelli Godbey

    > 24 hour

    Got 5 for 15 bucks or so Work like a charm will be ordering more...

  • Tung Mau Vu

    > 24 hour

    works as advertised. no issues so far!

  • L-Train

    > 24 hour

    They work very well. Only issue is the adjustment screw on 2 of them does not turn any more.

  • MJM

    > 24 hour

    I would buy again. Great price for what you get

  • raymond lee

    > 24 hour

    These work just fine. Remember to adjust the screw for what you need. If running for a long time keep a fan blowing on them or keep a few spares on hand.

  • Greg

    > 24 hour

    Ive used 1 out of the 5 drivers so far without any issues. Initially my order was shorted 1 item out of the 5. I contacted the seller and they sent out the missing piece. Overall I would buy from the seller again.

  • DrFrog

    > 24 hour

    No documentation make sure whatever you are replacing they are going in the correct direction as these are opposite of the ones you might be upgrading.

  • KC8IQW

    > 24 hour

    Excellent product. Was shocked to find out it supports 1/32 stepping. As always, very your voltage before attaching your steppers. Mine were all around 0.6V except one that was at 2+V which could have fried my motor.

  • CDub

    > 24 hour

    They worked OK but not an improvement over stock A4988s

  • Chip Stewart

    > 24 hour

    Works well for me. No quality problems. Would be nice to have decent instruction sheet.

1.A simple steps and direction control interface
2.Six different steps resolutions: full step, half step, 1/4-step1/8-step1/16-step, 1/32-step
3.CAN interface directly with 3.3 V and 5 V systems
4.Over-temperature thermal shutdown, overcurrent shutdown, undervoltage lockout
5.Short to ground short circuit load protection
6.4 Layer 2 oz copper PCB, in order to improve heat dissipation
7.Exposed solder ground below the bottom of the driver IC on the printed circuit board pad
8.Module size, pin and interface matching A4988 stepper motor driver operators in many ways
9.Adjustable current control lets you set a potentiometer, which lets you use the stepper motor"s rated voltage or more, in order to achieve a higher rate of maximum output current step
10.Maximum 45 V supply voltage

Package Included:

5* DRV8825 Stepper Motor Driver Module
5*Heat Sink

More Item:
KINGPRINT TMC2130/TMC2208 Stepper Motor Driver

NOTE:
If you find any problem, please contact us at first, and our technical staff will help you to solve the problem at once. Thanks!

Related products

Shop
( 1216 Reviews )
Top Selling Products
Home
Categories
Cart (0)
Messages
Account
0 Cart Item (s)

Your Cart is empty