





Micro Swiss .4mm Nozzle for Micro Swiss MK10 All Metal Hotend Upgrade Kit Only
-
Roberto Rodriguez
> 24 hourthese are the only nozzles i use but Ive said that before.....
-
Michael P.
> 24 hourI really like my upgrade to micros swiss hot end but this is the third nozzle that I have had to order for a clogging problem. I use a lot of wood filament so I guess after a lot of use you need to replace them. No problem with the seller or the order.
-
Quinn
> 24 hourThese were way better than what I got with my all metal hot-end kits. The hot-end kit nozzles worked good until worn out. But even then my z-height was always off a small amount. Finally discovered why, the extruded filament comes out of the nozzle with a diameter of about .6 on .4 nozzle. Replaced with this, which has a much more noticeable sharp tip and it extrudes filament right on .4mm. All my issues I had are now gone!
-
namestuff
> 24 hourNew favorite nozzle
-
R. Rockman
> 24 hourZero stars
-
Nerfherder
> 24 hourWork great, prints well. Takes some time to get the metal hot end dialed in but makes great prints when you do.
-
Russell Brown
> 24 hourIts perfect for small prints, creates much higher detail.
-
Robert R.
> 24 hourThe micro swiss all metal hotends are very nice. Just be sure to get a high temp Bowden tube, otherwise, it will start to melt.
-
Morgan
> 24 hourQuality is as good as a 0.4mm for what I am printing. The difference is it prints twice as fast.
-
Charles Lacey
> 24 hourNice nozzles! A direct fit for my Flashforge Creator Pro.