PGN UCP205-16 Pillow Block Bearing - Pack of 2 Mounted Pillow Block Bearings - Chrome Steel Bearings with 1 Bore - Self Alignment
-
Emilio Braun
> 24 hourThey worked
-
Adolfo Schuppe
> 24 hourGood product
-
Troy Rose
> 24 hourI had to tap the bearings with a hammer to make them straight but otherwise good
-
Jessica P
> 24 hourWorked perfectly for shop fan.
-
Michael Fallaw
> 24 hourLooks nice
-
GaryTaylor
> 24 hourJust what I needed for replacing the old pillow blocks for my 20 rock saw with something heavier duty and greaseable!
-
Rodney Johnston
> 24 hourSturdy and consistent in machining.
-
Flyer
> 24 hourThese bearings are a good value. They fit well. My problem is they will not withstand impact. The bases are cast material and brittle. I had suspected that would be the case, but was willing to try them. Four rifle shots into the morning and the target would no longer spin.
-
Running Man
> 24 hourI took a chance on these based on reviews that mentioned these bearings are self-aligning. Perhaps they are, but the hole bored through the casting that the bearing is pressed into is obviously bored at an angle relative to the rest of the casting and not in line with the mounting holes. I would either need to mount the casting at an angle or hope the self-aligning internal ring of the bearing did not cause ball bearings to run out of the internal raceway causing wear and premature failure. Pulling and replacing bearings is chore enough without worrying about doing it again sooner than necessary due to early failure of the part you are installing. I decided Im not risking it and returned them. Other than that, they appear to be of good quality and, if you can mount them slightly offset so the actual bearing itself is in line with the shaft, would probably work for you just fine. I dont have room to offset these on my brackets, so they are on their way back for a refund. I would be willing to try these again if I could confirm that they are being machined correctly or if I had an application with a little room to mount them at a slight angle.
-
Tom H.
> 24 hourThe ISO 9001-2008 died a few years ago. If you didn’t receive the 2015 rating, then you failed ISO requirements and can no longer say you are ISO certified. Who writes these things for these products?
