













RED WOLF Car Front Door Pro Tweeter Speaker Wiring Harness for 2008-2022 Toyota RAV4 Camry 4Runner Highlander Scion, 2010-2019 Subaru Forester WRX Outback Factory Speaker Replacement Adapter Connector
-
Preston S horner
> 24 hourEasy install
-
Paul C
> 24 hourThis speaker wire DOES NOT WORK with 2016 RAV4 with JBL system. I communicated with the seller that he/she should clearly label that this wire adapter is NOT compatible with any Toyota that is equipped with a JBL system audio system. It will work with non-JBL system however.
-
Vedran Simic
> 24 hourPurchased these to swap out for some better dash speakers for my 2021 Rav4. Works perfectly fine.
-
Cleo Gibson
> 24 hourThese did work on a 2021 Corolla. Also the speaker in that Corolla is about an inch and three eights it is connected straight to the sound grill. The JBLGX 328 speakers fit easily in the hole and are a giant upgrade but I could only get one screw to fit. Also because you were not pulling out a previous speaker you need some sort of screws. I used number 10 metal screws. They are a little loose but tightened up fine. The wires work as advertised plug and play. No problem fitting the wiring in the hole.
-
Maritza L Barajas
> 24 hourIt was easy to install my new tweeters with this adapter. I had to upgrade because the factory tweeters weren’t cutting it
-
Warpig
> 24 hourappear to be correct for 2020 Subaru Forester Premium but I cannot get them to latch and had to push them into the factory harness and then zip tie them end to end to keep them together. electrically they work. Physically they do not stay clipped together and pull apart.
-
alfredo garcia jr
> 24 hourExactly what I needed to hook up my dashboard speakers in my car. Fast shipping
-
Demonslayer1966
> 24 hourThese adapters are great! Perfect fit for my 2015 Toyota Highlander XLE dashboard speakers!
-
abdiel
> 24 hourVery good
-
Torstein Storli
> 24 hourIt is the correct harness, however it did not snap on perfectly. The connector is a little larger than needed, so the secure snap on the factory harness did not secure it completely in place. I put a tape strip around the connector to secure it.