RG58A/U COAX CABLE 3 foot Jumper for CB / Ham Radio - Workman CX-3-PL-PL -Made in the USA

It is exactly as i expected it to be.

Wire was soldered to connectors on both ends and cable works well with SWR meter.

Arrived very fast. Just as advertised Very happy with the purchase.

Perfect for my CB radio antenna tuning. Thank you. Jack

Awesome little jumper for your SWR METER

The connectors on the ends of the cable are cheap and easily break if over tightened. Dont overtighten!!! Other then that the cable works as it should.

this product sucks. the pl259 connectors are of poor quality 1. ive never seen a screw portion of the connector sit so crooked. 2. the soldering of the center connector looks like a toddler did it. when i first saw it, i verified with a multi-meter that their wasnt a short. 3. 1st time i used it, an antenna that i thought was pretty good showed me an swr much higher than i expected. it showed almost 2:1, and i expected 1.2:1 4. i then put the coax on an antenna analyzer with an 8 ohm dummy load. as i scanned through the frequencies, the analyzer showed swr of 1.6:1 up to 2:1. with any other coax that dummy load is 1.0:1 on every frequency. . not sure what kind of coax this is, because there are no markings on it. Im considering cutting a connector off and see if this wire is even coax.

Perfect jumper cable I use to set SWR on my antennas. Built very well and very little loss for f signal. Perfect cable for what it is

I needed a cable for my radio equipment. I didnt want to piece something together since I didnt have the scraps around. This was perfect for what I needed. Well put together, good quality. I would recommend this product I do not know the seller nor did I get any product or money for my random review 200605 1412

Did the job. Thanks