Rocaris 10 Pack Flap Wheel, 120 Grit for Rotary Tools，1/8 inch Shank (32X10X3)

I use this type of flap wheel all the time and have always purchased the name brand ones. It was just too tempting not to try these when I could get 10 of them for less than the price of two of the others. I was worried about durability. While they do seem to wear down slightly faster than those I had been using these are still a huge bargain.

When mounted in my Dremel rotary tool and run at maximum rotational speed, one of these flap wheels did a good job in… | • … removing a patch of rust from a badly rusted piece of steel (photo 1). | • … removing the OD burr from an abrasive-wheel-cut piece of conduit (photos 2A and 2B). The wheel ran smoothly, and I detected no obvious rotational imbalance, neither at the beginning of my tests nor at the end. I can see that these wheels will be a handy addition to my rotary-tool assortment. At this point I find no fault with this product and therefore give it a full five-star rating.

Does what it needs to do. Perfect for the do it yourselfer. Great for woodworking and other forms of hobby sanding.

Flap wheels are a staple in any rotary tool/flex shaft accessory kit; they offer an easy way to carve, smooth, and blend curved areas of a surface. The Rocaris 10-pack, at about $1 per wheel, is about one-half to one-third the price of my favorite name-brand flap wheels. As you might expect, theyre not quite as well put together as the more expensive versions: The glue joints can be a little uneven, the trim on the flaps can be kind of haphazard...but given the abuse these wheels get, its probably a minor issue. From what Ive seen in my first wheel, theyre not going to last as long as some, but again, at the price thats a minor issue. Less minor: They are positioned as 120-grit AlOx wheels, but as others have noted they seem more aggressive than that. The initial cutting is more like an 80-grit at least. However, after a couple hours use, they soften up to about where I expected them to be, out of the box. (Hint: If youre buying inexpensive abrasives, its ALWAYS a good idea to test them on a piece of scrap (metal, wood, glass, stone), and compare them to what youre used to.)

Working on a project with live edges and needed flap type disks. Fits perfectly in my rotary tool and allowed me to sand down the live edge without losing its natural beauty. A flat sanding disk wouldn’t have been able to handle the contour surfaces without removing excessive material. Overall excellent product and great addition to my rotary tool set.

these are just what they say they are and they do exactly what they are supposed to do. what more is there to say?

Tried these out in my drill and spent about 30 seconds polishing the rust off one half of my vise (see photo for before and after). It worked very well and Ill be using these to clean up a lot of items.

these are just what they say they are and they do exactly what they are supposed to do. what more is there to say?

I love em... I have used a lot of these over the years. These are some of the best I have used. They hold up well and also cut well. I would recommend these for your small finishing or trimminmg jobs.

When mounted in my Dremel rotary tool and run at maximum rotational speed, one of these flap wheels did a good job in… | • … removing a patch of rust from a badly rusted piece of steel (photo 1). | • … removing the OD burr from an abrasive-wheel-cut piece of conduit (photos 2A and 2B). The wheel ran smoothly, and I detected no obvious rotational imbalance, neither at the beginning of my tests nor at the end. I can see that these wheels will be a handy addition to my rotary-tool assortment. At this point I find no fault with this product and therefore give it a full five-star rating.