SPEED TIGER IPVE Carbide Square End Mill for Stainless Steel - Unequal Flute Spacing & Helix Design - Anti-Vibration - 4 Flute - IPVE1/44 - Made in Taiwan (1 Piece, 1/4)

product worked as expected.

This endmill cut .06 deep flats on 304 stainless 800 times. Then cut some plastic because I was too lazy to change it out. Cut like butter. Nice product!

Im new to milling and this bit is the best one I have used so far. Ive order one from a different company that was the best money can buy and unfortunately it didnt hold up to the speed tiger

Used this in my hand held air grinder. Works amazing, sharp, cuts great, proceed right, easy yes to buy this EM

Excellent

Excellent product, I was able to run an entire difficult job in stainless with them. Will buy again for sure.

Good endmill for price, will buy again

Great end mill for the money. Only used on aluminum, dont know how it will work on steel.

Ive used other bits, I could have been using a pensil eraser. I used these bits on my little milling system. They went through stainless steel BEAUTIFUL!!!!!

I use this as a router bit and its incredible. Ive routed fir, oak, mahogany, aluminum, brass, and thin mild steel. After 3 months of occasional use (only about 5 minutest a day averaged out) its still about as sharp as new. I use it primarily to open up strike plates for customers whose doors arent closing properly and its been a godsend. Try it out; what have you got to lose?