Thermalright Intel 12th/13th Generation LGA1700 Anti-Bending Buckle,CPU Stress Bending Correction Fixer, Curved Pressure Plate,Fully Fitted and Fixed Without Trace Installation (Black)

Combined this plate with a very slight undervolt on my 13700k and now its maxes out around 85C as opposed to thermal throttling before. 100% these plates are essential for keeping new Intel cpu temps under control.

Works as advertised definitely dropped temps byba few degrees only thig I wish I did not say Intel 12 gen on it not really needed and especially when your using it on a 13th gen

I used this on an Intel Core i7-13700K with an ARCTIC Liquid Freezer II 420 for cooling. With the stock frame a few of the cores kept spiking over 100C under load, forcing them to thermally throttle. Since the same cores were overheating every time, it seemed like the CPU wasnt properly mating with the cooler, which is exactly what this product is designed to fix.

Fácil instalación (tienes que ser extremadamente cuidadoso) se instaló con un procesador y motherboard nuevo, ayudó bastante en las temperaturas

facil instalacion y cumple su funcion

I tried this modification because I didnt like how much torque was being applied to my CPU when using the stock fastener. I am not sure if it was actually bending the chip but it was under too much pressure in my opinion. Temps improved slightly. Easy to remove original and install and looks cleaner than original silver clamp. Comes with tool to remove and reinstall screws.

This thing is so simple to install . Not expensive, but works like a charm.

Overall, Good frame, unfortunately I took off my old thermal grizzly (TG) paste and I went from an idle of 35⁰ to 42⁰ on a 13700k. So I reseated the cooler, same story. Finally I went to my microcenter and in a last ditch effort got more TG. After applying it, my cpu dropped to a cool 30⁰ this frame cost a fraction of TGs and gave me a 5⁰ drop and under load got my cpu to stop thermal throttling (on a liquid cooled system mind you)

As per gamers nexus and jays two cents, this provided a better pressure distribution on my cpu. Low profile and more reliable than the stock bracket

decided to rebuild my computer using a i7-12700k and from what i read and what all my builder friends told me, having this retainer is a must for the long term, as it helps mitigate temperature spikes and evens out the CPU to Cooler contact, allowing for an even heat distribution. Now, I’m not super computer savvy and I’ve only built 3 computers in my lifetime, but if I can install this easily, than anyone can.