Thermalright Intel 12th/13th Generation LGA1700 Anti-Bending Buckle,CPU Stress Bending Correction Fixer, Curved Pressure Plate,Fully Fitted and Fixed Without Trace Installation (Black)

Luckily I stumbled upon a video from Gamers Nexus highlighting these. Bought one because why not. Easy to install and it feels like my cooler is more secure than ever. I am running a z790 board with an Intel 13700k. My temps havent even needed to kick the fans on full blast yet.

This does what its supposed to do!

Excellent product.

Purchased this for my first Intel build ever. I installed this after using the stock bracket and seeing some relatively high temps. A quick search of Reddit brought up many recommendations for this, so I picked one up. It’s reduced the max temp on my 13700k from around 90c to about 85c with my EK Nucleus 360mm AIO. Definitely worth the cost IMO, even came with free thermal paste. I didn’t use the paste, but it’s a nice touch for sure.

Overall, Good frame, unfortunately I took off my old thermal grizzly (TG) paste and I went from an idle of 35⁰ to 42⁰ on a 13700k. So I reseated the cooler, same story. Finally I went to my microcenter and in a last ditch effort got more TG. After applying it, my cpu dropped to a cool 30⁰ this frame cost a fraction of TGs and gave me a 5⁰ drop and under load got my cpu to stop thermal throttling (on a liquid cooled system mind you)

This is my first build in 4.5 years, so this time around I wanted to do tons of research. Im installing a CPU water cooler for the first time ever and researching that a fair amount led me to these CPU brackets. Ive never been satisfied with the cheezy, light weight CPU brackets/fasteners which come standad on MBs. This seemed like a valuable asset for just $14. Im running a 13th Gen Intel on an MSI Z690 ACE MB. As you can see from the pic, the fit looks very clean and the aluminum bracket is well machined. I do not know if temps will be lowered vs the stock guillotine bracket but it sure holds the Intel in place far better. And that can only be good.

I didn’t notice a change to my thermals, but it makes my install look cleaner

I tried this modification because I didnt like how much torque was being applied to my CPU when using the stock fastener. I am not sure if it was actually bending the chip but it was under too much pressure in my opinion. Temps improved slightly. Easy to remove original and install and looks cleaner than original silver clamp. Comes with tool to remove and reinstall screws.

13900k/Liquid Freezer II 360/Z790 Aorus Master - no improvement in temps unfortunately. Well built and easy to install however.

Was skeptical at first even after watching all the videos online about this but it really worked, dropped my temps by about 5-7 degrees on both my 12th and 13th Gen CPU’s. Recommending this to all my friends!