Yonico 13168 3/4-Inch Radius Round Over Edge Forming Router Bit 1/2-Inch Shank

Excellent! Equal to many big name router bits, with a price lower than most!

This Yoniko Roundover bit is excellent. I am new to using a router (not to wood working) and was able to use it within 20 minutes of practice to make this oak display stand for my flintlock. I have to admit, I did watch a few You Tube videos first but I was surprised how fast and easy it was to shape the edge of a piece of oak wood. This is a sharp bit and it cuts effortlessly. Highly recommend.

Excellent! Equal to many big name router bits, with a price lower than most!

Makes nice clean cuts. Havent used it long enough to comment on durability and life. So far, no signs of losing its sharpness, but Ive only been cutting pine.

The bits come in a beautiful sturdy wood box. The carbide is very high quality and brazing is very clean on each bit of my set. The non-stick yellow coating is applied clean and even. The bearings are high quality and bolt down well and secure on to the shaft of the bits. The name on the shaft is put on neatly on each bit of the set. There was also an surprise coupon in the packaging for future purchases!. Bits run very well on the router and perform very well hand held or on the table. I have routed many feet of MDF, plywood and soft woods like pine. The bits route clean and there is no strain on the router, I feel that I was able to route my stock a lot quicker than with my lonely old round over bit this set replaced. I had only one scrap of poplar to try for hardwood and it did just fine. Tips: 1) as soon you receive the bits inspect them. 2) be very careful removing them from the box as the carbide will cut your fingers and you see it before you feel it. 3) inspect and clean the bits to remove the manufacturing sticky stuff. 4) The carbide edges on the smallest three bits can touch at their widest point when inserting in the box. Take care to stagger the edges so they dont touch. Update: I had an issue with one bearing and emailed customer support. I got a response in a couple of hours and they only asked for a picture of the errant bearing and mailed out a new one the same day. Thats good customer service. The feel good part of this event is that in the initial response, Jonathan the CSR advised that all the bits of the set have the same size bearing and I can swap them to finish my project in time. Saved my weekend. Thats thoughtful customer service. To watch the this brands bits in action view the review by WoodWorkWeb on youtube.

Great fit in the router, cuts well, at least on pine :)

Wood working

I am a professional custom woodworker, so I insist on quality results from the tools I buy. I bought this router bit specifically to make 1-1/2 roundovers on the ends of 1-1/2 thick pieces of white oak that form the base of the leg pedestals for a desk/writing table that I am making. Thats too much to take off in one pass, especially when cutting end grain, so I got the final result by taking off about 1/4 per pass until I got the full 1-1/2 radius shape. The Yonico bit cut each pass smoothly and easily, leaving a smooth surface with no chip-out or burning. I have always had good results with Yonico bits, and their prices are hard to beat for bits of this quality.

Nothing. The router bit performed well and good value for the price I paid.

Very sharp giving a smooth cut. Seems to be beefier than other bits I have used.