YOTOO Hybrid Air Hose 1/2-Inch I.D. by 50-Feet Long 3/8 inch MNPT Solid Brass Fittings 300 PSI Heavy Duty, Lightweight, Kink Resistant with 3/8 and 1/4 Industrial Quick Coupler Connectors, Gray

Well made lead line to go from the compressor to the wall lines. Note, this is the large fitting line! Will not fit your regular standard fittings. This line is meant to carry more flow to the hard lines throughout your garage. Be prepared to to have matching fittings on the compressor and the hard lines. I took a picture of the regular fitting next to this one, I hope it helps.

This is not some flimsy piece of hose. This looks like an industrial strength product. I have no worries that this will last a lifetime and never blow out.

This air compressor hose was much more heavy duty than I was expecting. It should hold up well for use around the garage. I wish my longer hose was as good quality as this one.

I got this air hose not realizing that it had the larger ends, luckily, it came with step down fittings. I like the fact that it came with high flow ends for purposes that would need them. I have had some of the pvc style hoses and they always get brittle and crack so i like the hybrid design. This hose is good for general purpose applications.

We use this hose on a reel in our work trailer. We build custom artwork crates and use this on the daily. During the work week. So far so good.

The way they shipped this is was kinked but came out easily and holds air well. No concerns for a lead in hose.

Easy-to install and easy to use. Fits 1/2 fittings. Great for nail guns or impact tools

I have yet to put this to use, I need to change fittings on compressor and my dryer system to use this larger hose. Since winter and do not use my shop very often in winter, will wait until spring to make those changes, things work fine for now. Everything had 3/8 fittings, so need 1 set to make this work for me. Look to be same size as what is used on my plow rig to quick release the hydraulics, so might have spare set if really looked around. I built a dryer system out of PVC with 4 drops to drain and few different regulators in place, and this feed hose will connect from compressor to that system.

So this hose seems good quality. Im using it from my air compressor to my hose reel in my garage and have had no leaks or issues. It came with some teflon and a couple air fittings. Not much else to say really. Its a short air hose. Most will use a 5/16 or 1/4 hose. 3/8 is pretty big so double check what your compressor runs best with.

This 25 hose was gotten to replace one that is leaking on my air compressor in the shop. This one is very robust, although the 25 length and large size can cause issues (in the way, trip etc.), it is a must when using air tools. The fittings are of decent quality and the hose isnt too hard to move around. As stated though it is 1/2 inch which makes it non-typical of the hoses generally used with pancake shop compressors. The included fittings, along with the thread tape are a nice touch. I did not get a hose with my brand new shop compressor, as such I used an old one from the bad compressor which is now leaking too badly to keep using. This hose replaces my old hose on the new compressor. I tested it with my 20 ton air jack and it worked well. Highly recommend this.