Comgrow 3D Printer Warm Enclosure Fireproof and Dustproof 3D Printer Tent, PVC Laminated Polyester Constant Temperature Protective Cover Room for Ender 3/Ender 3 Pro/Ender 3 V2/Ender 5 Pro

I received my second cover after my first one had some issues from some rain forest carriage. after talking with customer service on this directly I received my replacement, it was very quick and after assembly this is a amazing tent for my ender 3 pro. this is very good quality, with amazing customer service.

Great low cost enclosure

Was looking for a large enough and affordable enough enclosure for my mono x 6k because I honestly didn’t feel like building one. This was perfect. It may not be the best looking but as far as ease to set up and the size of it, I couldn’t be happier. I have a space heater set up inside enclosure too since the temperature has to be around 70-75 degrees to get good prints.

This does the job. Its a bit pricey for what it is, but they all are. It could have been engineered with less varied tube sizes, buts opts for four different sizes, so pay attention to the directions (its not hard). The corner joiners are plastic, so dont let anything stress them or youll be... printing a replacement piece, I guess. It is an absolute dust magnet. Thats fine, I wanted it to keep dust and drafts out, it doesnt have to look pretty while doing it. The important thing is that it fits the Prusa MK3S+ with room to spare. Now I guess I need to buy some LEDs.

Purchased for my Ender 3 S1, for whenever I get around to printing with filiments that either need heat retention or put off fumes that I dont want to breathe in, and just to minimize dust intrusion. Super easy setup, and Im sure it will last a long time.

The O ly thing I might have liked was a top cutout to feed filament I. From an above mounted filament dryer. Other than that, Ive had no issues with this, and its easy to assemble and disassemble.

Great enclosure. Been using in a cold garage and it keeps the heat in. I love it.

I’m almost positive this is actually a grow tent for growing indoor plants but it was the cheapest option and I’ve very satisfied. Helps hold in the heat perfectly and it help keeps dust from getting in during prints. My Ender 3 pro which has the spool up top fits perfectly with room to spare.

Nice product. Fit the laser well. Air exhaust port worked as expected.

A bit of a challenge to assemble but other than that no complaints from me. Its a nice little enclosure. I just wish my Elegoo Neptune 3 wasnt a POS.