Comgrow 3D Printer Warm Enclosure Fireproof and Dustproof 3D Printer Tent, PVC Laminated Polyester Constant Temperature Protective Cover Room for Ender 3/Ender 3 Pro/Ender 3 V2/Ender 5 Pro

The O ly thing I might have liked was a top cutout to feed filament I. From an above mounted filament dryer. Other than that, Ive had no issues with this, and its easy to assemble and disassemble.

Works good and easier to set up that I was thinking. Finally able to print abs.

Great product, Very big with plenty of room for my creality ender v2, and saved over $10 in costs. Assembly took a minute to figure out due to no instructions, but is very straightforward. Basically attach each pole that has a letter to each pole that doesn’t have a letter, so that they are 2 poles long. Then stick them in the white adapter, so that each letter is parallel to the same letter. Definitely recommend this; don’t waster your money on a more expensive one.

Crealitys printing enclosures dont fix the S1 or S1 Pro very well. The medium size is a little to small, and while the s1 fits in the large size, the large size is a huge footprint. This Comgrow enclosure it right in between the sizes of the medium and the large Creality enclosures, and fits the S1 perfectly. Note: The printer pictures is the S1 Pro, Ive just swapped the half-baked touch screen for an old school LCD that works.

Best

I used this to make a vacuum chamber for my 3D printer and it works perfectly! The product has a small smell to it when you first open it but it goes away after a week or so

Nice product. Fit the laser well. Air exhaust port worked as expected.

Purchased for my Ender 3 S1, for whenever I get around to printing with filiments that either need heat retention or put off fumes that I dont want to breathe in, and just to minimize dust intrusion. Super easy setup, and Im sure it will last a long time.

This is pretty great for the Enders, keeps most everything warm inside and away from the cold room, it also keeps some of the sound down if you have that issue. Down side its made of a semi sticky plastic/rubber. After awhile the stickiness dissipates. If you want a cover this is one to consider. no real issues with it

This was easy to put together, but it is too short for a base Artillery Sidewinder X1 with the spool on top. If you use a dryer box sitting on the side of the printer, like I do, it works well. I did have to cut a flap in the rear for the bed cable.