DEWALT DW2298 1/2-Inch Square to 1/4-Inch Adaptor Hex Rapid Load , Black

Typical great DeWalt quality

I was very disappointed in this product, having purchased it for an impact wrench attachment. DeWalt markets long bits specifically for that purpose ... they have a bit on both ends of the workpiece. Unfortunately, they go too deep into this attachment and get completely stuck. I finally drilled a hole through the bottom so I could drive it out. Very frustrating. Works fine for the short bits, but this defect would stop me from buying it if I knew it in advance. Fair warning!

Buena inversión

This NOT that well made of a bit holder. The wire clip that is supposed to hold the bit is weak at best. I was using a bit holder in the 1/4 hex slot and wire retainer finally gave up. I needed this bit holder to set screws in a deck with my impact driver. Ended up using Epoxy glue and glued the bit holder into the hex head and this worked ok. After this I ordered a Milwaukee Unit and is MUCH better made. This is not up to normal Dewalt Standards.

The adapter works well. However it does not stay on the tool as well as I’d like. Even with the ball in the detent, it’s sporadically falls off. Very good durability

It’s a cool idea, and it works , but I’m left wanting. It didn’t come with the pictured ring/pin holder, and it fits loosely which make bits wobble.

good product but does not include any instruction for application

Simple & effective. Adds versatility to 1/2 impact wrench.

I had to turn a torx head screw in and only had a 1/4 shanked bit to do it with, I used a 3/8 to 1/4 adapter with a 1/4 socket put the bit in the socket and promptly twisted it right in two. I bought this and it is solid as a rock, allows me to use my longer 1/2 socket wrench too.

Works well.