Rockford Fosgate P500X1BD Punch 500 Watt Class-bd Mono Amplifier
-
Matthew
> 24 hourGood quality amp. No complaints.
-
Kevin May Sr.
> 24 hourTHUS FAR, AWESOME AMPLIFIER, IF YOU ARE INTERESTED IN DEEP BASS, THIS IS THE AMPLIFIER FOR YOU
-
Edmund Jerde
> 24 hourI like it a lot and would buy again had no problems
-
Prof. Abner Hilpert V
> 24 hourBass is Rockford 12 and it sounds awesome. Worth the $$
-
Douglas Trevathan
> 24 hourIve had this in my 2000 Tahoe for about 2 weeks now powering Fosgate single P3-1x12. Advertised as 500watts rms, birth sheet says 773watts. Immediately after taking it out of the box, it is a little heavy and you can tell its a quality made product that Rockford is known for. I will definitely give my recommendation if anyone is considering purchasing this. Rockfords new C.L.E.A.N. setup is great and very simple, instructions included in the box on how to do it or their tech helpline is always great with lending a hand.
-
ljmitchell
> 24 hourHad a Boss riot 1100 in my crew cab gmc driving a single 12 shallow that I pulled from my old truck to get a little more thump. When I had the riot installed I was happy and thought it didnt sound bad, it went into protection mode a lot if I bumped it too hard. And one day I burned my hand on it so I stated searching for a 1 ohm amp asap. Well I installed this one and the paper said it passed with like 740-ish watts. Well I installed this with a good 4 guage wiring kit and all I can say is WOW! completely blows the riot away in every category! Which you would expect but dang, it just sounds so clean and crisp. I was thinking about buying 2 12s before but now it hits really good and Im completely happy! It hits clean all the way through and tuning it was very easy with the given instructions. It also looks clean with the hidden wire boxed area. Very happy, even though its more than what I wanted to pay since Im about to head to college but it is well worth it knowing this one will not catch my truck on fire!
-
Shawn Edens
> 24 hourThis guy delivers a punch espically if you have two 10 shallow mount speakers you can push almost 700w combined. well within range of your speakers and gets awesome bass.
-
Anthony P
> 24 hourNice amp, pushing a single 12 P3 at 1 ohm. Doesnt sound as good as my Skar Audio RP800.1 on the same sub but that one over heat after 1 hour of continuous use, this one doesnt break a sweat. It also pumps out much more power than its rated
-
Andy
> 24 hourI installed this in my c300 2009 Benz. I tapped off the rear sub w/ a line converter into this amp. During their CLEAN install the amp didnt clip on the input full volume.. nore did it clip on the output with the gain all the way up. wild. it kicks hard. I power a 12 P3 punch with it, custom box, absolutely amazing.
-
abrego
> 24 hourI know people give out birth certificate of watts and mine came out to 789 in one ohm. Mine is wired at two ohms and delivers 511. I highly recommend this amp.
Power & Bass On Demand!
P500X1BD
The Punch P500X1bd is a mono amplifier capable of producing 500 Watts into a 1-Ohm load.
Due to its dedicated low frequency response, this amplifier is optimized for mid-bass speakers or subwoofers only.
With its super efficient Class-BD circuit topology, the P500X1bd will drop some serious BASS! The stealth top mounted control panel not only provides a sleek finished look to the amp, but it also protects the vital controls.
Our custom heat sink design uses high aluminum mass where it is needed most to maximize heat transfer from the output MOSFETS to the surrounding air, keeping the circuitry cool even under high power and output demand.
- Punch 500-Watt Full-Range Mono Amplifier
- Rated Power: 150 Watts x 1 @ 4-Ohm OR 300 Watts x 1 @ 2-Ohm OR 500 Watts x 1 @ 1-Ohm
- 12dB/octave Butterworth crossover
- Power Wire Gauge: 4 AWG
- Speaker Wire Gauge: 8 AWG to 18 AWG
- Optional Punch Level Control Ready (PLC2 sold separately)
- Recommended Fuse (not included): 80 A
- Dimensions (H x W x D): 2.38" x 7.76" x 11.03"
C.L.E.A.N. Set-Up
C.L.E.A.N. (Calibrated Level Eliminates Audible Noise) is our patented circuit with in/out clip LEDs to help match a source to amp and optimize output
Punch EQ
Delivers more bass where you want it most by allowing up to 18dB of boost adjustment at 45Hz
Multi-Signal Inputs
The RCA inputs of this amp can accept both Hi or Low level audio signals without the need of a signal converter
|
|
|
|
|
|
|
|---|---|---|---|---|---|---|
| P1000X1bd | P500X1BD | P300X1 | P1000X2 | P500X2 | P300X2 | |
| Number of Channels | 1 | 1 | 1 | 2 | 2 | 2 |
| Total Power (RMS) | 1000 | 500 | 300 | 1000 | 500 | 300 |
| Bridgeable | No | No | No | Yes | Yes | Yes |
| Circuit Topology Class | Class BD | Class BD | Class A/B | Class A/B | Class A/B | Class A/B |
| Cooling | Convection | Convection | Convection | Convection | Convection | Convection |
| Recommended Fuse (not included) | 140 A | 80 A | 50 A | 140 A | 80 A | 50 A |
| Dimensions (H x W x D) | 2.38" x 7.76" x 13.28" | 2.38" x 7.76" x 11.03" | 2.38" x 7.76" x 9.86" | 2.38" x 7.76" x 15.03" | 2.38" x 7.76" x 13.28" | 2.38" x 7.76" x 9.86" |
| Rated Power | 300 Watts x 1 @ 4-Ohm | 150 Watts x 1 @ 4-Ohm | 200 Watts x 1 @ 4-Ohm | 300 Watts x 2 @ 4-Ohm | 150 Watts x 2 @ 4-Ohm | 100 Watts x 2 @ 4-Ohm |
| (or) | 500 Watts x 1 @ 2-Ohm | 300 Watts x 1 @ 2-Ohm | 300 Watts x 1 @ 2-Ohm | 500 Watts x 2 @ 2-Ohm | 250 Watts x 2 @ 2-Ohm | 150 Watts x 2 @ 2-Ohm |
| (or) | 1000 Watts x 1 @ 1-Ohm | 500 Watts x 1 @ 1-Ohm | 1000 Watts x 1 @ 4-Ohm Bridged | 500 Watts x 1 @ 4-Ohm Bridged | 300 Watts x 1 @ 4-Ohm Bridged |
|
|
|
|
|---|---|---|---|
| P600X4 | P400X4 | P1000X5 | |
| Number of Channels | 4 | 4 | 5 |
| Total Power (RMS) | 600 | 400 | 1000 |
| Bridgeable | Yes | Yes | Yes (front/rear channels) |
| Circuit Topology Class | Class A/B | Class A/B | Class A/B + Class BD (Sub) |
| Cooling | Convection | Convection | Convection |
| Recommended Fuse (not included) | 100 A | 60 A | 150 A |
| Dimensions (H x W x D) | 2.38" x 7.76" x 13.28" | 2.38" x 7.76" x 11.03" | 2.38" x 7.76" x 15.03" |
| Rated Power | 75 Watts x 4 @ 4-Ohm | 50 Watts x 4 @ 4-Ohm | 75 Watts x 4 + 150 Watts x 1 @ 4-Ohm |
| (or) | 150 Watts x 4 @ 2-Ohm | 100 Watts x 4 @ 2-Ohm | 125 Watts x 4 + 300 Watts x 1 @ 2-Ohm |
| (or) | 300 Watts x 2 @ 4-Ohm Bridged | 200 Watts x 2 @ 4-Ohm Bridged | N/A + 500 Watts @ 1-Ohm |