Spiral Flush-Trim Router Bits，Solid Carbide Flush Trim Router Bit 1/4-Inch Shank Spiral Flush Trim Up Cut from TACKPRO (1/4 Shank Up-Cut)

Worker better than perfect

I was excited to use this router bit. Unfortunately it broke after cutting about 10” of wood. I was cutting out a pattern in soft 1/2” plywood and the bearings flew off. This damaged my template and the piece I was cutting. Not sure what holds the bearings on but I found them on floor on a pile of sawdust. Very glad they didn’t fly off and hit me.

Bearings came apart after just a few uses. Switched to a Diablo flush bit 3 flute and that’s been working strong weeks now. I bought three bits from you. All three the bearings came off.

Trimmed without splintering

Great fast cutting bit, clean cuts

Used it to cut plywood out in window opening made it 2 inches snapped but it was a quick 2 inches. Disappointed to say the least.

I ordered this bit in hopes it would give me a nice clean cut with my router table. First one spun the bearing off within the first two minutes of use. I ordered a replacement and the second one snapped in half and flew across the shop after trimming about 4 of 1/4 acrylic sheet. Avoid this one

used this but 6 times to cut 1/4” abs, it broke and then got sucked into my dust collector. it dinged up my impeller luckily not damage to the router or myself. DO NOT waste your money, but an amana or whiteside instead of saving $20

Purchased 2 bits to router out Corn Holes. The first bit didnt even make a full circle and snapped in 2 pieces. The 2nd bit made the first hole, and I started the 2nd hole and it snapped. These are complete garbage, their durability is complete junk.

Cut very clean and without a lot of drag on the router motor...this is partially due to the small diameter, but also a sign of good design and sharp cutting edges.