StarTech.com 2U Vertical Wall Mount Patch Panel Bracket - Steel Rack Mount Bracket w/Hardware for 19 Network, Server and Data Equipment (RK219WALLV)
-
Jordan
> 3 dayThis is a great rack, I used it underneath a small sound booth counter for a few amps, wireless mics, and a sequencer. The included mounting screws are cheap junk. One screw stripped and one snapped the head off before being anywhere close to tight. I was using the proper Phillips bit and drilled pilot holes. If they had included proper lag bolts it would be and easy 5/5.
-
Patrick J Hufford
> 3 dayBought this to mount a 1u switch under my sit-stand desk. Works perfectly with a short-depth network switch. Makes cable management so much easier. Very sturdy with the switch installed. Zero worry about this causing damage to the wood desk or bending.
-
b.deren
> 3 dayThis makes any space a rack space :)
-
Nella Emmerich
> 3 dayIve done a lot of small/mid-size cabling jobs over the years and used wall-mount racks - but the horizontal kind that are cantilevered out from the wall. Its hard to find one thats deep enough to accommodate a typical switch (let alone a server), and if you do find one thats deep enough, the leverage situation means the maximum load is severely restricted. Over the years Ive daydreamed about a design similar to this, but had never seen one.
-
Starkie
> 3 dayWorks with our Dell edge switches. Perfect for switch closets without a rack!
-
Jeffrey Lee
> 3 dayI like this rack quite a bit. It seems sturdy and works well; however, it would have been nice if a few extra holes were drilled in the horizontal bar. Since I mounted this in a closet, I could not get any of the holes to line up with a stud and still leave enough room to work with on the sides. A hole or two in the middle of the bar would have helped.
-
Ray
> 3 dayThis rack is great
-
drivethecar
> 3 daySturdy, good hardware/screws for devices, good device clearance, highly recommend!
-
Waldo129
Greater than one weekWorks great. I have a PDU and a Cisco 3560 racked in my garage. Solid and sturdy.
-
Trevor MacArthur
> 3 dayLove this vertical hanging rack. Fits perfectly between floor joists for a basement ceiling install, or for any other place where you only have about 16 of room to work with. 4U was the perfect fit for this.
