Anycubic Upgraded ABS-Like 3D Printer Resin, Hardness and Toughness 405nm UV-Curing 8K Resin, High Precision and Easy to Post-Process Standard Photopolymer Resin for LCD DLP 3D Printing (Grey, 1kg)

Very very nice quality of detail for this one! - It’s done really well for models, miniatures, and works even better for printing lithophanes! Hands down would get this again! - Super crisp details and even thin pieces like sword blades on the minis haven’t been incredibly brittle like I’m used to - Hands down would get this one again!

A great resin I use it on the Anycubic 4K and it does a great job with perfect detail on all models I have printed

Took forever to calibrate my printer to use this resin in the first place (I have an M3, and the suggested settings on the product page werent even remotely close to accurate), but then once I did get my calibration prints to turn out perfectly, so there shouldnt have been any problems, I still couldnt get any other prints to actually work, including prints that have been proven to work fine with other resins. The amount of time and effort wasted trying to get this stuff to work is absurd. Honestly, since this is the first non-basic Anycubic resin Ive tried, Im not sure Ill ever be buying any non-basic Anycubic resins in the future.

First let me give you a couple of the particulars. Ive been printing for 2 years and this resin was used on an Elegoo Jupiter printer. The resulting print was washed in IPA, then cured in direct sunlight. I printed it solid, with no drain holes and the picture you see is before curing but after washing. All that being said, the resin performed well. Bed adhesion was good, details were not lost, and the finished product was a solid, strong print. I found it a bit tackier, even after washing, than most other resins Ive used but that does not affect the print at all. Once cured, the print was no longer tacky. My only complaint about this resin at all is that the fumes were much stronger than regular resins, water washable resins, or plant-based resins. It was so strong that it permeated my family room, on the opposite end of our large house. I wore a mask to enter the printer room, but I could still smell it. The Jupiter came with a built-in air purifier but that did not even put a dent in the smell. If you have a separate printer shop or are venting to the outside, you shouldnt have a problem with this, but for anyone else, the smell causes problems. Make sure to wear your protective gear. Aside from that, youll get good prints out of this.

vše ok

The quality and detail I get from this resin is astounding. Using the recommended initial settings from the Anycubic website and an old first generation Photon.

I ordered this resin because I have a Saturn 2 printer. PROS: Easy to use Low Odor Crisp Detail Higher flex CONS: None so far

This resin has been very easy to use. The odor is really the only drawback. It makes my office smell downright flammable so I decided to move the printer to my R&D shop where the ventilation is a lot better. I have used this quite successfully to add internal features to parts which I have made from carbon fiber. I like to use cheaper resins for the carbon fiber negatives and positives but this has been my choice for the permanently fixed components. It bonds well with 3M DP460. Good stuff!

Ça simprime mais pour le reste cest très décevant. Aucune résistance comme lABS comme il peut y avoir chez dautres fabricants. ça casse pratiquement comme de la résine classique. Cest de la résine + ! le plus ça doit être parce que cest beaucoup plus cher… autant rester sur de la résine de base.

No es una resina para hacer piezas que tengan que resistir tracción, pero los detalles salen muy bien.