Lift Supports Depot Qty (2) Fits Sonata 2015 To 2017 Front Hood 371418 5B-941221 81161C1000 81161-C1000 81161C1001 81161-C1001 81171C1000 81171-C1000 81171C1001 81171-C1001 PM3570
-
Looking For a Deal
> 3 dayTook less then 5 minutes to remove and install two of these. The hardest part, was untangling the rope that I used to hold the hood up (I tied the ends to the garage door hangers and looped it thru the hood latch - just be careful and make sure it is secure).
-
jerry kess
> 3 dayGreat product and much cheaper than the dealer
-
Rick
> 3 dayInstalled both in 10 minutes and works very well. I bought this to replace my OEM ones that had mysteriously stop working after I brought my car back from the dealer. Instead of bringing it back, I opted to go after market and I have to say, this was a great decision. Lets see how far these will last.
-
Phillip Croxton
> 3 dayProduct was too long as the photo reflects
-
margo
> 3 dayIt was so easy to install and works great on my car
-
pack8712
Greater than one weekproduct matched perfect with automobile, quality and less expensive
-
RISINALE0220
> 3 daySo far so good. Took me only 2 min per side with flat head screw driver. I own a hyundai sonata 2016. The fit perfect...
-
Sirfixalot
> 3 dayThe hood lift supports fit the vehicle as advertised, and are performing well.
-
Pedro G.
> 3 dayGreat product, easy to install
-
kizzy
> 3 daySuper easy… watched a youtube video and did both hood struts by myself in about 10 minutes. The dealership quoted me $533 to replace them!!!
Why Purchase from Lift Supports Depot?
|
|
|
|
|---|---|---|
Premium Quality SupportsLift Supports Depot supports undergo a vigorous QC process to help ensure dependability. Lift supports internal components get assembled and mechanically tested to ensure internal parts are not installed incorrectly or missing. OE quality seals are incorporated to prevent low friction losses and oil seepage. Airline hydraulic oil helps to avoid crystallization and blockage during cold weather. After painting and curing, lift supports are tested again for pressure and printed with final product information and lot numbers for traceability. |
Vigorous Quality Control ProcessThe supports are pressure-filled and tested one by one for forces to be within accepted tolerances. Pressurized lift supports go through a pre-paint phosphate treating process, which helps the paint adhere properly to the body of the lift support and gives a long paint life. Most importantly, an automated paint cabin is used for painting and curing in one place. Our lift supports never have premature rusting at the extremities due to the capillary effect of paint in bent areas. |
Easy to InstallMost applications are quick and easy to install. Often times requiring nothing more then a flat headed tool to remove and replace. The hardest part is often finding someone to hold the Hatch or Hood while you swap them out. |
Insert a Flat Headed tool behind the U-Band.
Slightly Pull Back on the U-Band, allowing the claw to release the ball stud. Careful that you do not remove the U-band from the Support.
Place new support over the ball stud and press the ball socket over the ball stud.
Once this has been completed for all mounting points, carefully tug to ensure all ball sockets are secure on ball Stud.