Oreck XL Vacuums Best Roller (1 Brush & 3 Belts)

Its close,and will work,but its not an oreck its a knock off.The belt seems really tight and wanders to the end of the motor shaft that turns it and rubs on the end causeing a burning rubber smell.I dont want to complain to much because it does work and they are resonable price.It could also be that my old oreck is out of whack.

After replacing the belts on my Oreck vacuum, its performance was still subpar. It didnt suck very well, and emitted a burning smell during use. After receiving and installing this new brush roller, my vacuum is back to its original abilities. Inexpensive, easy to install fix.

Ordered new brush and belt for vacuum, it came fast, fit perfectly.

I have an Oreck XL Pro Plus that is about 6 years old. Lately I just felt like it was really hard to push and wasnt sucking things up that well. I thought maybe I would have to get a new vac. I noticed the brush on my Oreck looked terrible, the bristles were all worn down and missing after so much vacuuming (I vacuum ALOT). I stumbled upon this new brush set and saw all the great reviews and decided for $12 to give it a try. WOW, my Oreck is like new again. Suctioning great, grooming the carpet great, super easy to push. It was so easy to change out too. Luckily my belt was in great shape after 6 years so didnt really need that but replaced it anyways. If your Oreck is not doing as well as before, get this, change the brush and it will be like NEW again! Cant beat the price. I think Ill start changing out the brush once a year or when needed since I vacuum so much. Love it!

This made her sweeper like new

The brush and belts fit my XL9100HG perfectly. The old brush had stopped turning smoothly; it seems that hair (human and pet) gets inside the bearing area and gradually stops the brush from turning smoothly so you need to replace it every few years. Once the brush stops spinning freely, the belts quickly burn up. To install the new brush, first slip the belt around the motor spindle, then around the metal wheel on the brush, then pull the brush back away from the motor until you can slip the black end in the slot. Make sure the New marking on the black brush ends (the end with the sawtooth pattern) is visible (facing the floor when in operation). After the brush wears down, you can rotate the brush ends 180-degrees so the Old mark is visible (closer to the floor when in operation) and the sawtooth pattern is inside the slot; the teeth push the brush a little closer to the floor, putting the worn bristles in contact with the carpet again.

Works like new! Holy Cow! What a difference this new roller made! I could see that the bristles were depleted but wow, like it was new! I did NOT realize the difference a new roller would make. 5 screws, lift off the bottom panel and replace the roller. I also replaced the belt...

30+ years Oreck still going strong, new roller brush and belt works just fine! I have no idea where the 9x2x2 measurement comes from but dont take any notice. It really is 11 1/8 inches from bearing plate to the edge of the drive pulley.

Easy to install & works just fine.

Appears to be well made. Havent yet installed it on the sweeper.