















SimbaLux Acrylic Sheet Clear Cast Plexiglass 12” x 12” Square Panel 1/4” Thick (6mm) Transparent Plastic Plexi Glass Board with Protective Paper for Signs, DIY Display Projects, Craft, Easy to Cut
-
susi Thomas
> 3 dayPerfect. Used it as a shelf in my refrigerator
-
Brandon
> 3 dayWorks on a rotary engraver, size is accurate. Was able to engrave straight through the backing, which acted as a mask so I could color fill with spray paint. The backing is paper with a plastic back, so would probably need to be removed to laser it, but I wanted the image deep into the plastic which I have always had better luck on the rotary with. I am sure it would look great laser engraved too.
-
Chris
Greater than one weekArrived in perfect condition. I was mostly worried about shipping damages, but it was packed well. This is perfect for my project!
-
Allen D. Reinecke
> 3 dayBought a 12 x 12 x 1/4 sheet of acrylic to make new foot plates for my trim router as the original factory foot plate is too basic and its center hole is too large for standard guide bushings to be fitted. The sheet arrived well-packaged in bubble wrap inside a form-fitting box inside a larger Amazon box, which also contained some Forstner drill bits I needed for this project. It measured 1/16th under the 12 inches on both sides. I assume that the original large sheet is marked at exactly 12 inches and the cutting blade running along that line has a width of 1/8. Hence the loss of the 1/16th inch per cut sheet. Not an issue for my project, but would be if someone wanted exactly 12 square. The brown paper protection was ideal for marking out the sheet and it was left in place until all cutting, sanding and drilling was completed. I was able to power sand the acrylic up to the lines on the paper without the paper coming loose or fraying. The acrylic cut cleanly with my table saw (40 TPI), jig-saw and it was center-punched and drilled cleanly on my drill press (1700rpm) without cracking or melting. In conclusion, I do not hesitate to recommend this product.
-
Bob R
> 3 dayQuality acrylic. Arrived on time, good value
-
mercedes sullivan
> 3 dayVery durable. It didnt break or crack rafter dropping dinnertime hard on it by accident. Dropped it on the floor and it didnt scratch
-
BJD
> 3 dayPurchased it to protect the top of a glossy black acrylic display pedestal. Looks superb! The protective paper cover was easy to remove. I would buy again.
-
BigFisch
> 3 dayIts clear. Its plexi, It arrived on time and undamaged. Im happy.
-
James Paskell
> 3 dayEasy to cut and clear. Meets my expectations.
-
GBA
> 3 dayThe cast Acrylic sheet was cut to size with smooth edge cuts. After cutting to finish size and drilling mounting holes, the fresh backing paper easily pealed off in one piece after I got it started; revealing a very clear finished sheet.