SimbaLux Acrylic Sheet Clear Cast Plexiglass 12” x 12” Square Panel 1/4” Thick (6mm) Transparent Plastic Plexi Glass Board with Protective Paper for Signs, DIY Display Projects, Craft, Easy to Cut

Excellent

Arrived in perfect condition. I was mostly worried about shipping damages, but it was packed well. This is perfect for my project!

Arrived in excellent condition. Packaged extremely well by shipper and as well by vendor. Quality piece of acrylic -as acrylic goes. No scratches. Protective adhesive backed paper on both sides; inside bubble wrap sleeve; inside form fit box; inside large box with inflated packing material. Will use as reflective base for product photography.

Works perfectly for calibrating air meters

The corner of the piece broke when I tried to drill a 1/4 inch hole on its corner. Looking at the piece the material had a texture that appeared rippled. I believe the piece had a defective spot in it. Luckily, I only needed half of the piece so I just used the other half.

The product was as advertised. 1/4 thick, clear as glass and easy to work with. I made a router base plate for a new dado jig I made. It cut clean on the table saw and was easy to drill. I even used an old1 1/8 spade bit on it and was able to get a perfect hole for the router bit opening. I will have no reservations buying this product again for future needs.

The product was exactly as described.

The cast Acrylic sheet was cut to size with smooth edge cuts. After cutting to finish size and drilling mounting holes, the fresh backing paper easily pealed off in one piece after I got it started; revealing a very clear finished sheet.

Bought a 12 x 12 x 1/4 sheet of acrylic to make new foot plates for my trim router as the original factory foot plate is too basic and its center hole is too large for standard guide bushings to be fitted. The sheet arrived well-packaged in bubble wrap inside a form-fitting box inside a larger Amazon box, which also contained some Forstner drill bits I needed for this project. It measured 1/16th under the 12 inches on both sides. I assume that the original large sheet is marked at exactly 12 inches and the cutting blade running along that line has a width of 1/8. Hence the loss of the 1/16th inch per cut sheet. Not an issue for my project, but would be if someone wanted exactly 12 square. The brown paper protection was ideal for marking out the sheet and it was left in place until all cutting, sanding and drilling was completed. I was able to power sand the acrylic up to the lines on the paper without the paper coming loose or fraying. The acrylic cut cleanly with my table saw (40 TPI), jig-saw and it was center-punched and drilled cleanly on my drill press (1700rpm) without cracking or melting. In conclusion, I do not hesitate to recommend this product.

This was, as defined, a piece of 12x12, 1/4 plexi - perfect for what I needed. I was packed in bubble wrap, free of scratches or damage.