Tasodin Water-Resistance IP65, 12V Waterproof Flexible LED Strip Light, 16.4ft/5m Cuttable LED Light Strips, 300 Units 3528 LEDs Lighting String, LED Tape(Warm White), Power Adapter not Included

Put these on my boat went out on the water and within 1.5 they were burnt up and sparking as I was loading my boat up. Any longer on the water and we would have been in full flames.

Adhesive gave up in a matter of minutes in a warm environment. Id pass on these. Also, the little solder pads are super fidly

I cut a short 5 foot section and wrapped it around the bowl of an outdoor dry fountain to provide a nice glow from the fountain at night. These are perfect as the light is warm, not too harsh. The thing that impresses me the most is that they have remained in full working order after 6 months in the Arizona summer. The fountain is not covered, so they have also been soaked in the occasional rains we get. The backing tape looks pretty beaten up, but what do you expect in the harsh environment they are being used in. I love it when something inexpensive totally out performs expectations.

I was skeptical at first how well the adhesive would stick but it actually done really well. I ended up buying 2 of the 16’ strips to go down each side of my 17’ Dominator Fishing boat and ended up having extra to go under my storage area and my dash. It has a cut line on it so you can cut off the excess off one end and you can just cut the adaptor plug off and strip back the wires and reuse. I ended up also purchasing the lighted rocker switch on here as well and it was a perfect combination! Really digging these lights on the boat. Looks like it was made to go where I installed. The width was around a 1/4” so it tucked perfectly under the lip on both sides of the boat. So far I’m digging it. I actually ordered my buddy some. After he saw it, he had to have it too! If I have some issues on it coming off I will update my review. For now all seems fine! Hope this helps someone.

Lights were very easy to connect to an existing circuit and switch on my camper, despite the fact that no instructions were provided with the product. Cleaned the side of the camper where they were to be installed (under the awning on the fiberglass siding) and allowed it to thoroughly dry. I then connected the wires and turne on the switch to make sure the lights functioned. I then started peeling the backing from the adhesive side and slowly sticking it to the camper. I must say the length was almost perfect. After installation I again switched on the lights to verify functionality, all appeared well at this point, very bright all LEDs appeared to be working. Two weeks later I am getting ready to pack the camper for a trip, all my lights are hanging down the side of my camper and in the dirt on the ground. I tried in vain to re-attach them to no avail, the adhesive simply would not hold

Got these to replace non-working lights beneath awning on camper. They fit well, a little narrower than original lights, but fit was good. Plugged into existing wiring, flipped the switch and there was light. I am pleased with this purchase

This product came with no mounting instructions and didnt function when I tested them. A waste of money.

Theses strips are awesome. For installing car audio and using small strips at times, a lot can be wasted. What was so awesome about these is that both sides are wired, so you can use both ends of the strip = less waste. Also, it seems these strips are more narrow than others. The only problem is will the adhesion, but that is the same with any strips I buy so I use something else to make them stick. Over all these are great. Will buy them again!

These are sold at a great price and seem to be of high quality. I havent seen any dead LEDs and they are quite bright, with an attractive color. I havent had these very long, so I cant comment on their longevity. I did buy the 3528 2 Pin LED Strip Connector Kit - 8mm LED Connector Kit for the installation, as I cut these into several strips. They are very clear about this not coming with a power adapter, so I also bought the Tasodin DC 12V 2A Power Supply Adapter to power them. No complaints, and I highly recommend them.

I used this to make an illuminated stripe in my garage to park my car. Installed it in a section of extruded aluminum, such that the tape is enclosed so the car tire cannot damage it, and yet it still lights up as a parking stripe. So far so good.