Thermal Grizzly Kryonaut The High Performance Thermal Paste for Cooling All Processors, Graphics Cards and Heat Sinks in Computers and Consoles (1 Gram)

Works as expected...

mis avec ryzen 7 3700x sous un 240 mm en watercooling avec comme technique détalage: pâte en crois

Hmm. I am impressed. easy to apply and better results than any other TIM i have used recently, including Gelid extreme! Currently using on my GTX 1080 as replacement and seeing 6C lower temps under load and 2C lower temps on my 4790K at 4.6ghz.

I used this to repaste my 3-year-old gaming laptop (MSI Raider GE 75) that was during normal (non-gaming) use was hitting 90 c with the fans at max. This replaced the hardening and overused paste that MSI put in. Now it has not hit 90 c with the fans not on unless I am gaming. If you need to revive an old laptop, video card, or CPU cooler this is what you want. You do not need to take my word for it as it has been used on world record-setting CPU benchmarks.

1g tube is poor value.

On first attempt at application, this paste was so thick that it wouldnt spread properly with the included spatula. I did some reading on ye olde internet and found recommendations to warm the paste before application - and so I did. It helped a ton and the paste smoothed out very nicely and looked like a really flat and excellent coverage job.

Its fairly enough for a one time use which I required and the quality I can say that its very good, as when I open my laptop to apply the paste I realized that the main problem with the thermals of my laptop is that the nuts which are attached to the motherboard to hold the heat pipes came off. That was the main reason for higher heat generation. But with this one now under the same situations temperatures went down by around 5 degrees centigrade which I think is quite appreciable.

This is what Ive been using for years, and until something better comes along that doesnt cost twice as much, its what I will continue to use for many more.

After seeing lot of reviews and lot of customer reviews from different websites. Spent nearly 2 days to decide the thermal paste. I came up with thermal grizzly kyronaut. My ryzen 3600x was getting heated up idle temps were 55 c, so I went with this along with a coolermaster ml 360r and a cooler master td500 mesh case along with a exhaust antec spark. Cooling inside the system is brilliant. Front panel sucks air and sends it to the whole system. The top is setup with radiator 360mm with 3 rgb coolermaster fans and 1 antec spark exhaust fan. Cool air comes inn and hot air generated goes out from the back

Look no further if you are looking for the best